Forum Replies Created
-
Posts
-
Re: Hotpoint BFI620 Door seal
good search colin, but that seal is for a slimline dishwasher, as far as i know its a comlete inner door.
Bob.
Re: Hotpoint Aqxxd169pm
im afraid not, only the programme selector knob is available without the front dislay pcb.
Bob.
Re: Who is Sovereign
Sovereign appliance marketing are no longer trading, most of the early appliances were made by haier, later ones were from china and far east places.
i will dig out my old database and see if that model is listed.Bob.
Model not listed :rolls:
Re: hoover washer oph7143 e14
e14 Missing Water Heating: defective NTC Probe and/or defective Water Heating Element and/or Wiring.
Bob.
Re: Aqualtis AQM8F49I Issues
if the sump was blocked you will have to reset the pressure switch, manually drain all water from the appliance via the drain hose by lowering it into a suitable receptacle. remove the pressure switch hose from the pressure switch and refit. Switch machine On.
Open door and fill drum with approximately 1 Litre of water. Close door. Set appliance to drain and start appliance; the pump will then drain the water out pressure switch and module now re-calibrated to zero.Bob
Re: integrated appliance
Fit the appliance into the hole make sure the appliance is vertical, measure the gap from the top of the decor door next to the appliance to the top of the appliance, then take the template and mount it the same distance as the gap down from the top of the decor door, mark and drill the hinge holes.
Bob.
Re: integrated appliance
all intergrated appliances are designed to be floor mounted, most washer and washer dryers have a gap at the top for ventalaion, what doe the installation instructions say ?.
Bob.
Re: hotpoint mistral fridge freezer
plase check that your fridge door has not dropped and not activating the light switch as this also stops the fan from running, a quick adjustment on the center hinge sorts this problem.
Bob.
Re: LG Washer WM16220FD OE error code
OE is a water outlet error code, check the pump, drain hose, customers plumbing, and not forgetting to clear the pressure chamber.
Bob.
Re: Beko DRCS68W broken belt
dont know which way you done it Allan but heres my way, 3 screws out of top, remove top, remove all the back screws but not the heater cover screws, remove the pump hoses from the top, pull the back compleate with the drum out just enough to release the heater and thermistor plugs, slip the belt on over the front of tub, and reverse, job done.
Bob.
Re: Hotpoint BWM129 cab cracked.
found it Jim, email address and i will send the info.
Bob.
EMAIL SENT.
