BobHope

Forum Replies Created

Viewing 15 posts - 676 through 690 (of 1,373 total)
  • Author
    Posts
  • in reply to: Norfrost Turbo 2800 Deluxe Twin Tub #329652
    BobHope
    Participant

    Re: Norfrost Turbo 2800 Deluxe Twin Tub

    Hi Al,

    i have the 2000 version service manual but dont know if it,s the same, i will email it if you think it might help.

    Bob.

    in reply to: Candy Washer CMD136 blown module #328857
    BobHope
    Participant

    Re: Candy Washer CMD136 blown module

    Hi John,

    ive emailed you some info.

    Bob.

    in reply to: Hoover HNFA390GB #328659
    BobHope
    Participant

    Re: Hoover HNFA390GB

    hi JJ,

    please check that model number or better still get the product code and seriel number.

    Bob.

    in reply to: Lux ER1632T Thermostat #328442
    BobHope
    Participant

    Re: Lux ER1632T Thermostat

    thats a larder type of fridge VT9 will fit, just hide the extra cappilary behind the evaporator.

    bob.

    in reply to: Lux ER1632T Thermostat #328440
    BobHope
    Participant

    Re: Lux ER1632T Thermostat

    good call Mat

    no evaporator show on the exploded so product code it is. 😳

    Bob.

    in reply to: Lux ER1632T Thermostat #328438
    BobHope
    Participant

    Re: Lux ER1632T Thermostat

    a k60 thermostat is an ice box type with or without pushbutton defrost it will not work in a larder fidge ?.

    Bob.

    in reply to: Lux ER1632T Thermostat #328436
    BobHope
    Participant

    Re: Lux ER1632T Thermostat

    VT9 will be ok but if you have too cold a fridge reported after fitting use the VX0.

    Bob.

    in reply to: Samsung rs21 defrost heater ohms #327933
    BobHope
    Participant

    Re: Samsung rs21 defrost heater ohms

    you might need a bigger fuse in the plug if your heater reads 5 ohms. 😉

    Bob.

    in reply to: Indesit IWDE12 not drying/Lights flashing #328130
    BobHope
    Participant

    Re: Indesit IWDE12 not drying/Lights flashing

    blocked fluff filter causes this fault.

    Bob.

    in reply to: CandY CM462 #327263
    BobHope
    Participant

    Re: CandY CM462

    sent you an email, which part is it you are after.

    Bob.

    in reply to: Water soluble bags??? #326629
    BobHope
    Participant

    Re: Water soluble bags???

    hi bazza,

    these bags are not recomended to be used in a machine that uses a pump to remove the water, as most commercial washing machines use a dump valve to empty the water i think any pump operated drain system might have problems.

    Bob.

    in reply to: Daewoo erf 368aeu #326561
    BobHope
    Participant

    Re: Daewoo erf 368aeu

    if its the glass type of heating filament tube it is 230v, 148 watts, 358 ohms.

    Bob.

    in reply to: Ind Is60v Wiring diagram #326458
    BobHope
    Participant

    Re: Ind Is60v Wiring diagram

    email address please John.

    Bob.

    in reply to: Kenwood ck440 – Base element #326444
    BobHope
    Participant

    Re: Kenwood ck440 – Base element

    remove back panel, locate the screws which hold the bottom plate and remove them, at the front locate the screws for the bottom plate (they minght not be there on some models) remove and the bottom plate from inside the pan draw, it will come down its bit fiddly but it does come out, replace element and reverse its not too bad just time consuming and fiddly.

    Bob.

    in reply to: candy gp482/1-80 #326360
    BobHope
    Participant

    Re: candy gp482/1-80

    E3, E16 are common known codes displayed when the heater insulation breaks down

    Bob.

Viewing 15 posts - 676 through 690 (of 1,373 total)