BobHope

Forum Replies Created

Viewing 15 posts - 661 through 675 (of 1,373 total)
  • Author
    Posts
  • in reply to: HAPPY BIRTHDAY BRYAN AKA R600A – 21 TODAY!!! #331627
    BobHope
    Participant

    Re: HAPPY BIRTHDAY BRYAN AKA R600A – 50 TODAY!!!

    Happy 50th birthday Bryan.

    have a good one.

    Bob and Rose.

    in reply to: samsung keeps freezing in fridge #331276
    BobHope
    Participant

    Re: samsung keeps freezingh in fridge

    Hi rickard,

    pm me or post up an email address and i will send you the info.

    Bob.

    in reply to: O Clipes for Dishwashers and Asko / ISE 10 Washers #331282
    BobHope
    Participant

    Re: O Clipes for Dishwashers and Asko / ISE 10 Washers

    yes they do.

    bob.

    in reply to: O Clipes for Dishwashers and Asko / ISE 10 Washers #331280
    BobHope
    Participant

    Re: O Clipes for Dishwashers and Asko / ISE 10 Washers

    Hi Burns

    those clips and pliers are available a lot cheaper than that from a company called BES, they supply gas fittings, there site is dowm at the moment for maintainace but just google it and look in the LPG section for the clips and pliers.

    Bob.

    in reply to: samsung keeps freezing in fridge #331274
    BobHope
    Participant

    Re: samsung keeps freezingh in fridge

    Hi agro,

    there is a mod kit available for this problem.

    Bob.

    in reply to: Hotpoint FF200E Fridge Freezer #251173
    BobHope
    Participant

    Re: Hotpoint FF200E Fridge Freezer

    Hi Jem,

    the new heater is larger and extend down to the fridge air return slot to stop it iceing over.

    Bob.

    in reply to: Bosch dw door seal #331156
    BobHope
    Participant

    Re: Bosch dw door seal

    the numbers are etched into the top of the door in the centre, you need to be at the right angle to see them correctly.

    Bob.

    in reply to: Hotpoint FF200E Fridge Freezer #251171
    BobHope
    Participant

    Re: Hotpoint FF200E Fridge Freezer

    hi Jem,

    you have email.

    Bob.

    in reply to: Indesit dishwasher (IDL 540 UK 2) #330573
    BobHope
    Participant

    Re: Indesit dishwasher (IDL 540 UK 2)

    Hi Graham,

    part number C00114403 or C00143209 fit this appliance both are called bit 100 timers.

    Bob.

    in reply to: Hotpoint Dryer Mod TCD970P #330943
    BobHope
    Participant

    Re: Hotpoint Dryer Mod TCD970P

    F07 Lower element failure • Check security of module connector J4;
    • Test between pins 4 and 3 on J4 (approximately 48 Ohms);
    • If open circuit, test lower element and wiring between J4
    and the heater.

    Bob.

    in reply to: Hoover HNC170 #330506
    BobHope
    Participant

    Re: Hoover HNC170

    hi Tim

    part number is 03870618 drum scrowl.

    Bob.

    in reply to: Descaler #330244
    BobHope
    Participant

    Re: Descaler

    if its the hotpoint descaler it does not have a shelf life and the date you are reading is its manufacuring date.

    Bob.

    in reply to: hoover HNL 616-80 core board #329831
    BobHope
    Participant

    Re: hoover HNL 616-80 core board

    Hi Jim,

    ive emailed you some info.

    Bob.

    in reply to: Hotpoint ST55X Oven 312110059 #329662
    BobHope
    Participant

    Re: Hotpoint ST55X Oven 312110059

    Email sent,

    Bob.

    in reply to: Hotpoint ST55X Oven 312110059 #329661
    BobHope
    Participant

    Re: Hotpoint ST55X Oven 312110059

    Hi Mike,

    PM or post up your email address and i will send some info.

    Bob.

Viewing 15 posts - 661 through 675 (of 1,373 total)