Forum Replies Created
-
Posts
-
Re: PAT Testing
Who should carry out the Inspection and Testing?
The Electricity at Work regulations states that:“No person shall be engaged in any work activity where technical knowledge or experience is necessary to prevent danger, or where appropriate, injury, unless he possesses such knowledge or experience, or is under such degree of supervision as may be appropriate having regard to the nature of the work”
The IEE Code of Practice states, those carrying out the inspection and testing must be competent to undertake the inspection and, where appropriate, testing of electrical equipment and appliances having due regard of their own safety and that of others. What should be considered is that the ‘danger’ to be prevented, includes not just the dangers which may arise during the testing procedure to the tester and others, but also the dangers which may arise at a later date as a result of using equipment which has not been effectively tested.
The tester must have an understanding of the modes of electrical, mechanical or thermal damage to electrical equipment and appliances and their flexes which may be encountered in any environment.
Training must include the identification of equipment and appliance types to determine the test procedures and frequency of inspection and testing. Persons testing must be familiar with the test instruments used and in particular their limitations and restrictions so as to achieve repeatable results without damaging the equipment or the appliance.
for your info.
Bob.
Re: Hoover OPH714D/1-80
Geoff,
pm me an email address and i will send you some info on the coreboard.
Bob.Re: Hoover OPH714D/1-80
hi Geoff,
pump gets jammed burns out the winding which then goes short circuit this then overloads the triac on the coreboard which the goes pop and leaves a perminent suppy to the pump.
coreboard part no. 41026074 not programmed, 49015449 programmed.
Bob.
Re: ZAN ZWF 10070
check for earth leakage on the haeter or motor with an insulation tester my bets on the heater. 😉
Bob.
Re: americanf/f
SWERV,
you have mail. 😉
Bob.
my email sent to you has bounced back do you have another email addy.
Re: Samsung SR-L3626B fault code RD?
Hi Carl,
you have a problem with the damper/baffle or one of its componants.
Bob.
