BobHope

Forum Replies Created

Viewing 15 posts - 1,126 through 1,140 (of 1,373 total)
  • Author
    Posts
  • in reply to: Refrigeration training #167342
    BobHope
    Participant

    Re: Refrigeration training

    Hi Gav28,
    im looking into this problem at the moment but if you want to go it alone and have £500.00 to spare i can give you a contact.

    Bob

    in reply to: Lost Contact #167214
    BobHope
    Participant

    Re: Lost Contact

    hi
    i think dave went to expert 😥
    and i dont know abt paul
    two good lads thats for sure.

    Bob.

    in reply to: Liebharr fridge freezer U/G agent #167169
    BobHope
    Participant

    Re: Liebharr fridge freezer U/G agent

    Hi Mbdas

    model no. please.

    Bob.

    in reply to: Samsumg B1215JGW1/XEU #167174
    BobHope
    Participant

    Re: Samsumg B1215JGW1/XEU

    Hi Mbdas,
    looks like the bearings are part of the backhalf.
    do you have an email address if so PM me. 😉

    Bob.

    in reply to: sharp microwave parts no;/prices/availabilty #166842
    BobHope
    Participant

    Re: sharp microwave parts no;/prices/availabilty

    Hi Tel
    i see that you are in co. durham not very far from me, i have them parts in stock.

    tel 07860 486679

    Bob.

    in reply to: servis m6005 door #166510
    BobHope
    Participant

    Re: servis m6005 door

    hi wilf
    had this problem before, was the door interlock the same as the one you took off the appliance or was it looks the same differant colour, if so the door latch pecker does not make contact, dont ask why but a genuine interlock solved the problem somthing to do with the length of the door pecker catch according to servis technical.

    Bob.

    in reply to: Swan Freezer,Fridge/Freezer parts sourcing #166501
    BobHope
    Participant

    Re: Swan Freezer,Fridge/Freezer parts sourcing

    Hi Biggoolie
    this appliance was badged Swan for the littlewoods group,
    it is also badged for quite a few other makes as well.
    as for the thermostats a normal vt9 fits most larder and f/freezer units just keep the spare capilary wound up tight in the thermostat housing.

    Bob.

    in reply to: Kenwood dishwasher #166125
    BobHope
    Participant

    Re: Kenwood dishwasher

    Hi kwaremont
    try connect distribution services (Electrue) the model is listed on there web based order system
    this is a Haier made appliance the parts may be available from other source.

    Bob.

    in reply to: hpt minstral ff92n #166093
    BobHope
    Participant

    Re: hpt minstral ff92n

    Hi Bryan
    its the evaporator one that causes this (yellow plug)

    Bob.

    in reply to: Candy Fridge Freezer problems #164415
    BobHope
    Participant

    Re: Candy Fridge Freezer problems

    Hi spikydiner
    the pcb control module has failed.
    time for the engineer to call, click on the repair toolbox on the lefthand side for an engineer close to you.

    Bob.

    in reply to: CDA integrated dishwasher CW495 keeps fusing electrics #164198
    BobHope
    Participant

    Re: CDA integrated dishwasher CW495 keeps fusing electrics

    Hi Dawn
    dont think the two faults are related, ask the repair agent to adjust the door balancing, its possible the heating element has failed and that is what is causing the electric fault. you dont use 4 in 1 dishwasher tablets by any chance.

    Bob.

    in reply to: GUNKOL FOGH SS Oven – blowing out cold air. #166014
    BobHope
    Participant

    Re: GUNKOL FOGH SS Oven – blowing out cold air.

    Hi AlanLFC,

    do you have the full model number please, its located on the top of the oven so you will need to remove it out of the housing about 6 inches to see it, the no. has the letters GB in the middle.

    Bob.

    in reply to: CDA integrated dishwasher CW495 keeps fusing electrics #164196
    BobHope
    Participant

    Re: CDA integrated dishwasher CW495 keeps fusing electrics

    hi dawn,
    its quite common for the door hinge assembly to become damaged by poor instalation, does your door fall down when you open it, if so the fitter has not adjusted the door balancing system correctly, this fault can be repaired in your home.

    Bob.

    in reply to: LG WM1290 #166031
    BobHope
    Participant

    Re: LG WM1290

    Hi Bill,
    i hade one with poor wash perfomance and it turned out to be a blocked air vent in the soap dispenser causing presure in the tub due to air not escaping, this made the water pressure sensor think it was full of water but it only reached the bottom of the inner tub. had me baffeled for half an hour before i found it.

    Bob.

    in reply to: Candy Fridge Freezer problems #164413
    BobHope
    Participant

    Re: Candy Fridge Freezer problems

    Hi Spikydiner

    your fridge freezer does not have a thermostat fitted its controled by an electronic pcb.
    if you turn the temprature control to the 0 position does your fridge stop working or keep running.

    Bob.

Viewing 15 posts - 1,126 through 1,140 (of 1,373 total)