Forum Replies Created
-
Posts
-
Re: Beko WMA 510
Hi, Johnny how you doing? I suspect module also as have had a few on this model.They have been a problem from new, the dealers were complaining about excessive numbers of this model (1000rpm) not spining. Bruce.
Re: Belling Oven
looks like a Hotpoint/ Creda manufactured oven?
If it is? a 6222922 door seal will fit.Re: Hotpoint Fridge-freezer RF64
This model has 1 operating stat in fridge, other stat in freezer is a signal warning stat only. I can only guess that this appliance is sited in a cold location? e.g. garage. If this is the case you will find that the appliance is OK and is suffering from low ambient temp. not allowing the stat in fridge to raise temp. enough to cut back in again. Thus stopping operation + losing freezer food. Cold winter day?
Re: hotpoint vtd00 pulley
If you have a X245677 jockey pulley, this will fit, I have removed the pulley + fitted it to a CTD00P- pulley identical.
Re: miele dishwasher g673 all lights flash
Have same fault as yourself, all lights flashing, did you find problem? Bruce. Miele G679SC-VI-2. WATER FOUND IN BASE, but cannot reset module, maybe a PC need to reset as port to plug in avaiable to upgrade software?
Re: hotpoint TDC62G killing toc’s…
Yes, heater can stay on if module is faulty even if selector switch is set to on, had afew tripping green spots+ found with help of clamp on ammeter.
Suspect stuck relay on dryness module.Re: Indesit W123S Carbon brush replacement
Had similar problem with brushes bedding in on Candy, Found if you filed shiney edge off brush, seemed to bedin easier.
Re: TEKA ADW6 59FI VR01 dishwasher module
😀 No longer required. Job done found solution on tech forum .Just had to reset module. Magic site, thanks again.
Re: WHIRLPOOL AWM6145/3 – STICKS WITH 1MIN ON DISPLAY
Returned to reasses fault but desturbing connections last visit seems to have cleared fault , going fine now. Thanks meantime. Bruce 🙂
