Forum Replies Created
-
Posts
-
Re: Whirlpool AWOD 4505 ‘service’ ?
Any progress with this one Jim ❓
I have same model with identical fault.
Probably the PCB but just wondered if a slightly stretched belt can cause this problem even without a load.
Seem to remember fitting a new belt for a similar fault on some Servis machines as the slightly stretched belt is simulating OOB conditions.
Didn’t have a belt to try unfortunately 😥Bryan
Re: Tecnik D/Oven TKC8525/2 (058587098)
Ok Andy, thanks for that I’ll order it from Masterpart tomorrow :D.
Don’t know why BSH quoted me that part and it does refer to Bosch for spares in the owner’s user manual 😕
Bryan
Re: Tecnik D/Oven TKC8525/2 (058587098)
Thanks Gerry, have done a bit more searching around and BSH spares came up with part no. 841018. Hope that helps anyone for future reference.
Bryan
Re: More pattern pump problems.
Yes Martin, I remember discussing this a couple of years ago when I had this problem with low cost Bosch pattern pumps.
I unscrew them from the housing, stick them in the bin where they belong and fit a Hanning pump with confidence it’ll do the job intended.Bryan
Re: Whirlpool AWZ451-1X-01
Hi Martin
I’ve got the 481925928823 element in front of me and the terminals are spaced at 23mm from centre to centre.
Can’t say I’ve ever seen an element with 12mm gap between terminals, so duff info. on the Qualtex site perhaps ❓Cheers for looking anyway 😀
Bryan
Re: Stoves Cooker ES550DODLM
ANDYVIVO wrote:Hi Bryan & Martin,
For the grill element with kit 011561400 in stock, or HY14103 without kit (out of stock).Thanks Andy, I actually have HY14103 in stock 😯 😀 .
Good luck with your module Martin, something tells me it’s going to be expensive.
Bryan
Re: Stoves Cooker ES550DODLM
ANDYVIVO wrote:For there products the 9 digit SKU product number is required to check on parts.
Thanks Andy, 058542041 is the 9 digit number.
Bryan
Re: Hotpoint brushes part no?
Not sure if this is one of them trick questions Martin but I think it’s 1603910 :D.
HTH
Bryan
Re: What would you do?
In these circumstances I sometimes ask if the elderly person has a relative I can phone to explain the situation and whether they want to check the operation of the appliance before I call again and again :idea:.
With regard to the original question of the possible blocked filter there’s no way I’d ask the customer to check the filter for the reasons already given by reaper.
Oh , and also because I need the money 🙂
Bryan
