[cab]

Re: CREDA slot in 48356

some machines have a door switch so the grill will only work with the door in the correct position

cab

[cab]

Re: white knight 767C ser. 0309 368 710 tumble drier

Hi they sometimes get blocked with fluff etc, I allways blow down the hose, pour some water down the hose then run it see if it pumps.

cab

[cab]

Re: D Detrich DOD338XU11 element fitting

Hi. tin snips! cut away the cover, then bend it back, this is the official Brandt advice for repair.

cab

[cab]

Re: beko wm fault

have had loads of these timer main fault but could be the module.

cab

[cab]

Re: daewoo fault codes

going tomorrow, just now its showing a code, I asked the same question in January, with no reply. The model i have is dwd1210.

Thanks

cab

[cab]

Re: ZANUSSI TCE 7276W

it is in the facia when you push the start button it pushes on the diffuser (a piece of clear plastic that connects all the buttons and neons) onto the pcb buttons, its common.

cab

[cab]

Re: Gas Bolier queiry

hi we had a new boiler about 18 mth ago, they removed tank in loft and tank in immersion cupboard freeing up space, any decent corgi installer will tell you what size of boiler you will need depending on the no. of rads. and cant see a problem with lpg, i’m sure there is one too suit.

cab

[cab]

Re: ZANUSSI TCE 7276W

diffuser is probably broken, its the bit that connects between the pcb and buttons 125 11 85-30 / 0

cab

[cab]

Re: servis wd M9003w-a

yep, I would expect any problem with over heating would just cause it to end the program, but not to advance thru to next wash prog. I fitted the bits, ran it and it moved on after 11 mins, switched the machine off megad elements etc, switched it straight back on, so it would have still been hot, and it ran for 11 mins again! weird.

cab :bounce:

[cab]

Re: speed sensors

CHECK MIDDLE WIRE ON THE THREE PIN PLUG TO MOTOR.

[cab]

Re: LG WASHINGMACHINE WM1480FHD

if you run the test program you can hear it rumbling away at around 45 rpm above this it disapears.

cab

[cab]

Re: LG WASHINGMACHINE WM1480FHD

ON SLOW TUMBLE THE DIRECT DRIVE MACHINES DO MAKE LIKE A GROWNING RUBBING TYPE NOISE, EVEN AFTER REPLACING ALL BITS ETC.

CAB

[cab]

Re: AEG L12700VIT no display after testing pump terminals

did you get the info I sent you?

cab

[cab]

Re: zanussi da 4342 poor performance

Hi the pump might be running slow, not pumping enough upto the top basket, or there might be a restriction in the top arm feed tube.

cab

[cab]

Re: AEG D/W 40850 Won’t Heat

YOU HAVE MAIL.

CAB

[Author]

Posts