Forum Replies Created
-
Posts
-
Re: Whirlpool Upright frost free freezer which arent frost f
cut a piece of wire, I use the capillary of an old stat, wrap it onto the defrost heater and position it in the centre of the hole.
cab
Re: beko
hi, not many intermittant probs on these but what I have had is if different people use the machine they dont line up the program marks properly!
just a thought!cab
Re: LG 16336FD WASH/MACHINE
nothing wrong with it, the fuzzy logic control has detected an uneven load, but it doesnt abort the program and show the UE code. Have had loads, LG advise to tell the customer to fill the machine, not very good if it is a 8kg drum and an old couple that only has small loads.
cab
Re: zanussi tumble dryer model tce7276w
Hi I have had a problem with a diffuser today, the 1st i,ve had trouble with. Is there a few badly moulded ones about?
Thanks
cab
Re: zanussi IZ16 91451300500 wash rinse spin lights
it might be your email is incomplete. he may have sent it to co.uk instead of com.
I shall send it to you.
cab
Re: zanussi small condensor dryer model FD 10
the main fan is on a splined d shaft, it knocks on the little fan wheel is held on with a spring clip.
Re: zanussi small condensor dryer model FD 10
did one yesterday. take the tank out, remove back cover, take of fan drive belt, remove right side panel (as you look at the back) the motor is visible, get a towel on the floor and stand the drier on its top, there are only two screws that retain the motor mounting then you slide the mounting plate forward to release it, might need a screwdriver it prise it a bit, take off the wiring and the motor is out, there is a service manual on tds, can supply it if need be.
cab
Re: Zanussi D/W DE744 Water Valve Locks Out With Pressure Ch
have sent the service bullitin to your business email.
cab
Re: Zanussi D/W DE744 Water Valve Locks Out With Pressure Ch
hi I carry it as van stock, involves replacing existing vavle with a new vavle with a double coil, adding a pressure switch and modifyin the wiring ,takes about 40 mins.
cabRe: TC470 Door Lock Cables
Hi I’ve allways packed out the buttons, works 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time.
cab
Re: FISHER & PAYKEL DD603 SN. CSM704924
Hi, they arnt that bad once you know! If you pull out the bottom drawer and look on either side, near the bottom front you will see a round pin, with a tab in it. get a good set of pliers grip the tab and pull the pin out, this will allow you to pull the draw off the runners.
There is an antiflood device, most come problems is leaks from the lids not closing properly, too much foam. the sensor for the antiflodd is on the pcb which is lovcated under a plastic housing in the base.
If it isnt draining check the hoses, you will see them when you take the draws out, some suffered from the hose mounting assembly breaking.
good luck! 😯
