Forum Replies Created
-
Posts
-
Re: Zanussi ZFK 47/52RF Fridge Freezer Tripping RCD
Yes there is only two reasons why this would trip and thats the element or compressor so given that you disconnected the element and runs it has to be the element . You need to remove the draws and then the internal rear panel which will then exspose the evaporator and element assy . not a big job .
Re: u3100-4-m
When the old element has blown it seems it may of fused the contacts on the selector switch in front of the thermostat together you need to check this
Re: Zanussi washing drum not spinning in operation or stoppe
You should be able to turn by hand so either you have something like a sock jamming the drum (usually the sock would be wedged between the door seal and the drum) or the bearings have collapsed and seized
Re: Zanussi TD 4112 W
I didnt say you didnt have to take it apart of course you do !! ( At least take the right side panel off any way )
Re: Zanussi TD 4112 W
Make sure the vent is not blocked and has good airflow.This model has a thermostat at the front which can give trouble sometimes
Re: Belling Platinum db3 main oven thermostat problem
for the connection to of burnt out suggests the amp tag was only loosely fitted onto the terminal and has begun arcing . I would be contacting the repair company and insist they repair their mistake fast !!
Re: Baumatic B187SS-B Randomly Losing Power
I would firstly check (if its on a socket) that the plug is fully in socket or that the socket and the plug arnt burning out check the pins of the plug for signs of arcing if its wired to the wall then i would check the connection there and the isolater switch. If thats ok it could be the internal cut out at the back of the cavity inside the appliance that needs renewing.
Re: zanussi de6965 salt level indicator problem
yes it could do . salt dosent need filling that often so rather than replace the tank just keep it topped up to the top (as long as your not using those combination tablets)
Re: zanussi de6965 salt level indicator problem
The sensor is on the outside of the salt container its either the float thst has stuck or the reed switch but first try filling it to the top with the salt but if your using combination tablets that contain the salt then you dont need it anyway
Re: Zanussi WJS 1265W Question
i agree with martin its defo the motor brushes zanussi part no 50226588007
Re: Zanussi WJS1265W – button selection clears on start
bigcol78 i never said you were wrong but what was wrong and i hadnt reliazed you had replyed as im still getting used to how this forum works being a newbie else i wouldnt of posted. I agree on changing the board if its the early version with the solder tracks on the one side but if its the later then theres no point
Re: zanussi de6965 salt level indicator problem
it works by a ball which passes a reed switch on the side of the tank it can be a while before the light illumites when low on salt though also some versions have a 3 in 1 or multi-tab button if you have have either and you have selected it then neither the salt or rinse aid lights will illuminate
