Forum Replies Created
-
Posts
-
Re: Siemens HB86K570B FAULT E17
Called today, hob thing a red herring. The oven goes to E17 even when not in use. Have quoted for new relay board,customer thinking as BSH don’t have one in stock. Thanks for your help Paul.
Regards claysideRe: Siemens HB86K570B FAULT E17
Thanks Paul,
This oven had E16 showing in September, I switched it off and on and fault cleared. Think this may have been early signs of board failure. Will keep you posted.
Regards claysideRe: Siemens HB86K570B FAULT E17
Can anyone help with this please. Does anyone know what E17 is
claysideRe: Miele G1220sc dw not drying
Vent fan mounted towards the right at plynth level on this I think
claysideRe: miele G1530 SC [D/W] – spray arm LED illuminated…
The spray arm light indicates middle spray arm not turning, the middle spray arm has a small magnet in one end that sends pluses to a switch mounted in the detergent dispenser each time it passes by.
It could be customer has loaded an item stopping spray arm turning, spray arm could need cleaning or the circulation pump has a diverter that alternates water feed from top middle/spray arms to lower spray arm and this could be sticking. claysideRe: Miele W310 Washing machine.Drain prob.
Have had a couple with this intermitant fault and both times PCB
Make sure you order correct one by type or ser no as I think three
types fitted to this model.claysideRe: Miele W522P
Remove kickplate/plinth either by two capped screws or if later model it just pulls off. Remove two torx screws holding door lock , remove door seal band and release door seal from front panel,at six o’clock position onder door remove either 10 mm bolt or large torx screw, under front panel where plinth came off their are four small torx screws, two on left hand side and two on right, remove the outer one on each side only. Then front panel should pull away at bottom and then downwards and off.
Hope this makes sense. claysideRe: Siemens HB86K570B E16
Have been out to look at oven. Switched it off mains to remove from housing, when I swtiched mains back on oven works ok. Have tried all functions including microwave all works.Users instruction book says E16 is technical fault send for engineer. Any ideas as I’m sure this will come back and sting me.
clayside
