Forum Replies Created
-
Posts
-
Re: wf620 rear tub
Many thanks for replies.Tub is buff so prob 30mm. Bearings not gone in m/c. Nails caught between heater and outer tub and heat melted hole into outer tub.
Re: Pulling machines out on board
A deep pile rubber backed door mat turned upside seems to work fine for me. Slides easily.
Re: commercial dishwasher
Many thanks for that Dave.Having a look again tomorrow so its great to have that info.Paul
Re: Hoover DYN8144D
This one is back. Husband describes smell as like burnt out clutch type of
smell. Going back Monday. Any ideas.
Re: hotpoint sy36k fan motor
Thank you Dave.It makes for expensive repair for single oven considering element usually gone as well by time they realise fan not working properly.
Re: wf000p
Thank you for reply.replaced pr sw and checked module connections.fault still remains.checked tube.did reset procedure on pr sw. m/c in shed with seperate fridge and freezer.all being fed by ext lead and variety of multiplug adapters.Hot plugs allround.advised that this was a fire hazard and that they needed a mini consumer unit wired into shed.
