[Dansta]

I’ve filled in the registration form to list my business in the “find an engineer” section but I get an error every time i try to submit it.

[Dansta]

Sorry, I’m asking if anyone works for the company directly as an engineer and if so what are they like to work for? Thanks

[Dansta]

Drum maybe?? I’ve had issues where the shaft joins the spider.

[Dansta]

Re: Bosch WF02864GB/01 wash cycle stuck 0:01 minutes remaini

Rather than over complicate things id check the connections to the element, I’ve found them burnt out on several occasions, if there ok, the element should read around 30ohms, worst case will be the pcb. Unplug before testing!

[Dansta]

Re: wf430 shutting down

Does it only play up on the spin cycle?

[Dansta]

Re: BSH

Thanks for the reply. Currently working for a big and very demanding company so can’t imagine they could be any worse, that may just be wishful thinking though.

[Dansta]

Re: SMEG DWF614SS dishwasher not washing

Seized or blocked wash motor/ faulty start capacitor for wash motor.

[Dansta]

Re: bosch WAE244S0GB/ 15 washing machine not draining

Hi Bryn, if the machine is still full of water and your sure the drain hose is clear it must be a blockage In the sump hose which connects the tub to the pump.

[Dansta]

Re: AEG lavamat turbo 16830, not drying clothes

Sounds like air flow is being restricted, possible fan housing/ blower wheel clogged up?

[Dansta]

Re: Resetting clock on Bosch hbn331eob/04 oven

Hi,

I’ve had the same fault a few times, new clock seems to solve it, I used to have problems with brand new ovens but that was down to reversed polarity, clocks didn’t like it. Hope that helps.

Dan.

[Dansta]

Re: Bosch wf02264gb01 spin problem

It’s normal for the time to jump from 7 to 1min if your testing with no load because the machine has nothing to balance-out so it will just skip to 1min and carry on spinning, had me confused when I first noticed it. Maybe it could be down to unbalanced loads,not draining properly or the customer is just paranoid after the repair.

[Dansta]

Re: Zanussi ZWF1432

Could be earth leakage from motor or worn empty pump.Dan

[Dansta]

Re: Bosch dishwasher S5456X1GB12 stops with 1 min in display

I find that replacing the pressure chamber usually sorts that fault,cant be cleaned properly bacause its sealed(its the one which connects to the ribbed hose).Otherwise it may be fault with heater unit or even module.Hope that helps mate,Dan

[Dansta]

Re: HOTPOINT FFS70 – fridge not cooling – freezer fine

Is your f/f the frost free type,i.e no soft ice on back wall of fridge and no ice build up on shelfs in freezer?Dan

[Dansta]

Re: U1524NOGB/01

I’d go with the temp sensor mate,ive had the same problem a few times and its never been the p.c.b,reading sounds about right aswell,Dan

[Author]

Posts