Forum Replies Created
-
Posts
-
Re: hotpoint 9414
Unless anyone has got one on the shelf, both wash and spin motors are now very obsolete I’m afraid 🙁
If you have good wash one you can change the stators over, they’re both the same 🙂
Dave.
Re: Whirlpool ADG957 fault
The PCB constantly monitors all components from power on.
If any are faulty and depending on which component has failed, it may abort the cycle switching the pump on to empty any water that may be in there. The NTC is one such failure that causes total abort so nothing will work until it is replaced.
Hope that explains it 🙂
Dave.
Re: Neff S435OXO dishwasher leaks
Yeah, I found that as well but Seamy says Neff say it’s obsolete 😕
The online partfinder doesn’t tell you stock levels unless Martin rang them ?
Dave.
Re: Neff S435OXO dishwasher leaks
It’s a Bosch, the old Hotpoints also made by them use seal part number 7082894, you could try that one 🙂
Dave.
Re: Whirlpool American style F/Freezer
gazzer wrote:Where is the main pcb board located?
At the rear of the appliance as is mentioned above 😉
Dave.
Re: Zanussi 1600 XC WJD1667W Error Code
E90 is a communications error between the electronic PCB’s.
If you use the search function here:
http://www.ukwhitegoods.co.uk/modules.p … ile=search
Then search for E90, there’s loads of Zanussi ones there which will help but it’s one for an engineer to be honest, check the repairs@ link below 🙂
Dave.
Re: Zanussi 1600 XC WJD1667W Error Code
duncan_1978 wrote:Hi everyone, I was wondering if anyone knew what the error code above is all about
What error code Duncan, you haven’t told us what the error code is ? 😀
Dave.
Re: samsung FF parts
You can’t buy it seperately, Samsung only supply the whole evaporator but you can carefully remove the heater and swap them over.
Part number is DA96-00013B
Connect or SEME will be able to supply 🙂
Dave.
Re: Brandt CFA361XU Freezer Problem
zander wrote:my post code is en8 if there is any one who can sort this.
Follow the repairs@ link below zander, there’s various Independent repairers listed there who can help 🙂
All should be able to source Brandt spares easily enough but I can help if you get stuck.
Dave.
Re: Diplomat ADP 3101 oven will not heat up
The fan element has failed I would think, a common enough problem 🙂
You can get one here:
http://www.ukwhitegoods.co.uk/modules.p … cts_id=308
Power off before attempting a repair :zap:
There’s a related thread here with tips etc:
http://www.ukwhitegoods.co.uk/modules.p … pic&t=5736
If you’re unsure, please check the repairs@ link below for an engineer 🙂
Dave.
