Forum Replies Created
-
Posts
-
Re: User Instruction Booklet
I’ve just read it Martin 😀
Many thanks for an absolutely superb job :tup:
Dave.
Re: moffat MSS600
MSS600 is a good model but there are two versions both with different seals.
Can you post the PNC and I will sort the part number for you.
Dave.
Re: belling oven element
If you’re using the DVD still it probably isn’t on there, I can’t remember how to do it offhand but you can update the DVD from one of the menu options 🙂
Dave.
Re: belling oven element
This one’s made by Merloni (Servis).
Part number 082614366 (was FS865045).
Connect show their ELE9028 as a pattern replacement
Dave.
Re: Diplomat DW ADP8132
iadom wrote:Any idea what 4&5 flashing mean, not listed in the info I have?
It doesn’t mean anything (unknown code) so suspect dispensor coil 😉
iadom wrote:Also what are the two small slotted plugs near the top outer edge of the door on either side for, are they supposed to hold the panel on, do they turn or push?
They hold the panel on and are sprung loaded (pull directly outwards), there is a special “key” tool but you can normally coax them out with a screwdriver if you’re careful 🙂
Dave.
Re: Zan FLE 1416W
Can you acccess the configuration/diagnostics ?
Press the SKIP/RESET button to cancel the programme previously selected and switch off the appliance.
Press the START/PAUSE button together with the SKIP/RESET button and then, holding down both buttons, press the ON/OFF button to switch on the appliance.
Hold both buttons (START/PAUSE and SKIP/RESET) down until the buzzer sounds and the LEDs begin to flash (about 4 seconds).
At this point, the display board is checked and the LEDs (and, if featured, the display window) light in sequence.
If it won’t accept that then the control PCB is the culprit I would think…
Dave.
Re: smeg sra25x2 ****how much ***
’tis correct 😯
Ludicrous, as if anyone is going to pay that much for a bottle shelf :con:
Dave.
Re: smeg sra25x2 ****how much ***
Email sent to Smeg requesting confirmation 😉
It looks like a GE this one as it turns out (now I’ve looked at the diagram).
Dave.
Re: Stoves Q900EM – DBIO
Chris, drop me a PM about this, I will find something but it’s time consuming (so I don’t forget ;))
Dave.
Re: Bosch wff1201GB/01 motor toc blown
It looks like it Simon 🙁
Nothing else showing apart from the brushes or the whole motor, part number 141344
Dave.
