Forum Replies Created
-
Posts
-
Re: Brandt dwf681wu/1
The two small half racks (on the left of the basket) support clip is part number 31X8904 or the long wire rack on the right comes complete with the support(s) and is part number 31X6770 🙂
Dave.
Re: Indesit D63
You’ll need to test the valve for continuity (with the power off :zap:) to check it but it sounds more of a restriction as it slowed from a trickle to now stopping.
Is the fill hose kinked or the tap faulty ?
The valve is here should it prove to be the culprit:
http://www.ukwhitegoods.co.uk/modules.p … cts_id=468
If you’re unsure, check the repairs@ link below for an engineer 🙂
Dave.
Re: Indesit C239NK How does it work
It relies on cold air being “blown” in to the fridge from the freezer by a fan motor.
You could try a total defrost as it may be blocked with ice in the freezer restricting the air flow.
If that doesn’t work, it’s engineer time for one of these electronically controlled units to be honest, check the repairs@ link below 🙂
Dave.
Re: Ultima WD865 Woes
iadom wrote:All these instructions are normally included with the parts. ❓
Nope, I sent the part personally, nothing in there apart from the new heater box as supplied by Hotpoint 😕
Re: Ultima WD865 Woes
I think johnny refers to having to remove them to gain access/fit only rather than remove them completely 😀
Dave.
Re: Homark Oven
Is there any heat at all when the oven is on, this model uses combined heat from the upper (outer part of the grill) element and a concelaed base element ?
It may be that the lower and possibly the outer of the upper element have failed.
Dave.
Re: Homark Oven Door
Slash wrote:Can you please tell me if these hinges are still available?
Yep, they are 😀
Part number 031199009909R at £15 each inc VAT plus carriage.
An email to spares@ukwhitegoods.co.uk please if required
Dave.
Re: Hat Off To You All
loki wrote:Cheers Daniel, Sam, Hannah and Stacey.
And thanks to you for the feedback, it’s much appreciated 😀
Dave.
Re: Norfrost twin Tub
Direct contact information is here:
http://www.norfrost.co.uk/general.htm
I believe JTM are now the WP handling the work
http://www.ukwhitegoods.co.uk/modules.p … ic&t=13406
Or possibly Qualtex have spares 🙂
Dave.
Re: Smeg DWI 67.1 pump problem – advice please?
db2boy wrote:If I order the part number given I will receive this new piece and it will be the housing as shown in my link?
Yes 😀
Re: Smeg DWI 67.1 pump problem – advice please?
The hose is still connected in the other photo making it appear shorter 😉
Also, yours has the newer version fitted (note the two holes where it’s fixed to the motor), Smeg have superseded the part number which is the one you have in your picture so the part number is correct 😀
Dave.
Re: Smeg DWI 67.1 pump problem – advice please?
Amazing, three in one day 😀
Different model but it’s the same part number etc as this one:
http://www.ukwhitegoods.co.uk/modules.p … ic&p=79163
Dave.
