Forum Replies Created
-
Posts
-
Re: Help Me To Help You!
i cant find the report button i i just get a 404 error page not found all the time
Re: hotpoint valve problem
no clue as to the link there but and of the machines with the click clunk door lock that locks then does nothing is always the board maybe i am wrong in this case but i recon a lot of these and have sent 4 boards to emw today 3 of them with door lock then sit there and do nothing and they will all as usual come back fixed and the machine will be fine
maybe the valve was the cause in this instance maybe it was just a coincidence if anyone else knows please enlighten me too as these are becoming costly to meRe: hotpoint valve problem
seen a few like this door locks machine sits there sometimes after about an hour you get f01 i have always sent them to emw and got them back working always been a pcb fault to me
Re: wdl520
and there are only 4 options so i cannot even read them lengthways but if anyway knows a way of converting it then let me know
Re: wdl520
these dont have the smae fascia no dig display for an f code and the options are along the bottom with program progression on the right
Re: hotpoint aquarius door fault
wiring on motor loads
hinge bent done a lot
spring on handle dodgy seen one
pcb more than a couple
door interlock…so far neverRe: Bosch Dishwasher Fire!
oh yes the hoover dryers with noisys pulleys not a hard job just one of those you look at then sign as you remover a whole truckload of screws
Re: Hotpoint ctd 80 p
is this the one with the pump impellor is a sort of strange elastic thing if so they come loose and the pump run but no water will be shifted
Re: White Knight CL847 not drying.
i press all the right keys just not necessarily in the right order
Re: Bosch Dishwasher Fire!
hmm we should start a new thread what machine we would like to see this nutter strip down and blow up
any suggestions??vtd00 dryer
Re: This morning’s entertainment……….
£200 for an element i charge £45 and about £20 for the element on average i think thats more than fair
for £200 i would change her the fan motor and thermostat as wellRe: Hotpoint WT960P not working
i would imagine the main pcb has failed possibly got wet during the work
remove the module and inspect it for signs of damage with a popping noise usually very obvious damageunplug and leave the machine ten minutes and make a brew first before touching the module they have a nasty habit of shocking even when unplugged
