[delta01]

hi just noticed your post i had this and it turned out to be the heater thermostat only on some models does it cause this problem i appreciate its probably too late but good to know for future reference
John

[delta01]

thanks will do

[delta01]

thanks Dave will check out John

[delta01]

Re: wmud942 display faint

thanks all for your help

[delta01]

Re: Hoover vtc 791nb-80 stops and starts

yes it does it at several times during the timed drying cycle thanks

[delta01]

Re: Hoover vtc 791nb-80 stops and starts

thanks it heats up ok the customer thought it was getting too hot but i ran it a few times and it worked ok except it stopped several times can the ntc be tested easily

[delta01]

Re: Bosch WTE84105GB/31 stops after 10 mins

thanks Mo3426 will investigate

[delta01]

Re: sharp washing machine fault codes

thanks don i have sold over a hundred of these washers and found the service to be generally good , my only quibble is they wont compensate ( time and labour ) if a return is actioned maybe i am speaking to the wrong people

[delta01]

Re: Beko WM74135 no motor action

thanks for input wilf i repaired tracks on module motor it now goes up to full speed then stops i ordered a s/h module so will try that i think it blew because one brush was right down i cant see any obvious motor problems

[delta01]

Re: Beko WM74135 no motor action

thanks is that the one on the side is it repairable

[delta01]

Re: Hoover DXA48W3/1-80 No display

thanks for suggestions will try them john

[delta01]

Re: Creda TVU1

Hi I sorted this the small panel behind facia just needed some capacitors I replaced the oblong one adjacent to the relay and three small round ones
Only cost a few pounds I would put a picture but don’t know how to
Hope this is useful
John

[delta01]

Re: Creda TVU1

Thanks all for your help John

[delta01]

Re: Creda TVU1

hi Dave the board is similar but only has 3 connections

[delta01]

Re: zdc37200w stops after a few seconds

hi Sorted it, i removed c/p could not see any faults so i clouted the three relays in case one had stuck and it works fine now result

[Author]

Posts