[delta01]

Re: LG WM16220FD Bearing change

its the bearing seal for LGs that is extortionate last one i did was £18-00- ish from connect , if my memory serves me well

[delta01]

Re: aeg w1259

thanks chris

john

[delta01]

Re: Length of program cycles

might be a silly question but i have heard that american machines use a special powder and do not heat up at all , if this is true why are we not doing the same ? a massive energy saving

[delta01]

Re: dvd help

thanks squadman
job sorted

working fine

john

[delta01]

Re: zanussi wdr1030 bearings & seal part no’s

thanks dave, the last cwd zanussi i did the bearings on had a special type double seal, this model is a 1000 spin, i have the kit for the thin shaft ones in stock, think i will strip it down to see which it is first

[delta01]

Re: hoover six/nextra series, tapping noises!

i have had several similar faults on various hvr autos, some caused by coin or coins jammed in pump causing excesive vibration on spin , some pumps with the long tube type housing easily get 1p coins etc stuck in , and can be missed if not checked carefully.
allso the bolts go right into the rear tub requiring complete tub replacement, i usually recommend scrapping the machine in this instance

[delta01]

Re: hvr pe 235 not heating

thanks dave. brilliant !

[delta01]

Re: hotpoint tl31 timer

yes thats why i haven’t done anything with it yet , i was kind of hoping someone had some old stock or even a good s/h one , shame to scrap it as the machine is in otherwise excelent condition

[delta01]

Re: ise washers

thanks k.
will peruse said forum

[delta01]

Re: wont start

thanks dave, will recommend replace machine with more reliable make,
john

[delta01]

Re: tc480w belt snapped

thanks for suggestions,will implement them.
john

[delta01]

Re: poor spin full loads only

thanks dave will investigate

[delta01]

Re: stuck on spin, no access to diagnostics

no did not suspect tacho as motor action seemed fine, would faulty tacho cause syptoms described ?

thanks for your reply, john

[delta01]

Re: urgent ! wanted handle kits hpt 9306 etc

thanks for reply have back orderd some with qualtex but not sure of the timescale

[delta01]

Re: urgent ! wanted handle kits hpt 9306 etc

thanks for replies can you supply masterparts tel no. i have never used them thanks again -delta01

[Author]

Posts