Forum Replies Created
-
Posts
-
Re: comet…again!!!
You need to read the headline from the link Martin 😉
DRL are not interested in the bricks and mortar.
Don
Re: Motor has smalls flashes when turning only counterclockw
Martin wrote:
I’ve never heard of a Seg myselfS and A are next to each other on keyboard maybe it’s an AEG 💡
It also appears the OP is posting from Germany so it could be that I’m wrong and it’s a local brand 😉
Don
Re: Zanussi Frost Free Fridge Freezer NOT Frost Free!!
Hi
It may be that the freezer door has been left open for a sustained period allowing warm air to be sucked in.
You will need to empty appliance, pull the plug and with some towels on the floor of freezer leave the doors open for three days to allow it to defrost. Placing a bowl of hot water in the freezer will speed up the process.
If the problem persists then it will be time for an engineers visit.
HTH 🙂
Don
Re: Help please AEG Lavatherm 56840L >Expensive/failed early
What’s in a name here. May just surprise you.
Don
Re: Help please AEG Lavatherm 56840L >Expensive/failed early
Hi
This very subject was covered on Daily Watchdog this morning about faulty appliances approx twenty minutes in.
Also a good read is our advice section here article 2 is a good start.
HTH 🙂Don
Re: Shallow depth washing machine – what is a good machine?
Martin wrote:What’s a “like” button?
Don
Re: Shallow depth washing machine – what is a good machine?
Good shout Swerv 🙂
“Like” button would be good for this sort of reply 🙂
Don
Re: Shallow depth washing machine – what is a good machine?
As an update 😀 and having a little dig around in the old brain cells which doesn’t take too long 😆
The only two slim depth washing machines in recent years have been the Bosch WLX24162 44cm deep and the Indesit IWSC5125 at 45cm deep. Not the greatest of sellers which is why they are no longer available.
A long shot I know but you could try ringing around dealers in your area who may have one left in stock.
Don
Re: Shallow depth washing machine – what is a good machine?
Hi
Bosch may go but it will be tight by removing the worktop lid and adding the height reduction lid WMZ2420 will reduce the depth from the rear bump to the front of the door trim would be 55cm as long as your plumbing is coming from the side as you only have about 3cm along the bottom.
An alternative cabinet would be the new Hotpoint WMEF range which are only 55cm deep overall.
It may be time to take your tape measure and visit a local retailer to see what I mean.
As the good Doc says 53cm is very shallow 😉
HTH 🙂
Re: teka washer dryer tone
Hi
If there is nothing in your user manual I would fire of a message from the contact form here
Don
Re: 1950’s Admiral Fridge Spares
Hi
You could try this USA forum based web site as a start point.
HTH 🙂
Don
