Forum Replies Created
-
Posts
-
Re: Liebherr Sgnes2800
Hi Steve, part nos 6118102 motor and 6299995 fan blade.
The blade needs to be ordered if you need a motor.
You sure it’s the motor?
Give me a call on this if you want mate.
Cheers.Re: Liebherr error codes for SWTNes3010
Hi mate, it’s not giving you a fault code though is it?
You’ll need to find out if the compressor will run or not.
Try pressing the up button and the off button at the same time, that should put you into the service menu.
Toggle the up button till you get the ‘L’ menu. Select that and see if the compressor will run.
If it runs, the the fault will be down to the control, ie sensor or pcb.
Getting into the ‘E’ menu should give you the value that the sensors are reading. If one of these is way out, then that could very well be your problem.Re: Liebherr CUN 3031 not cooling
hello chris, reading this again has me wondering if you’ve fully defrosted the freezer before starting it again.
the small pcb you changed controls everything and so the evaporator if the freezer may not have been having a defrost.
if this is the case, then just changing the pcb wouldn’t have had much immediate effect.
you’ll have to fully defrost the freezer too.
turn off, leave the door open for a good long while. maybe 24-36 hours to be certain and then switch back on again.Re: Liebherr CUN 3031 not cooling
Have you tried this site?
Not that I’m aware of any terms or conditions that may prevail, but it’s worth a try.Re: nardi oven parts
Sorry just seen the replies to this.
Yes Bryan we’ve spoken to AWS this week and they’re adamant that there’s only one fan motor.
Andy, I called earlier and got your voicemail. I’ll call you Monday am.Cheers.
Re: nardi oven parts
This is giving us headaches. AWS only list a screw fit fan motor, for the nardi FEA0614X, but the one on the appliance is a bayonet fit.
Has anyone else had this problem and does anyone have the part number for the bayonet fit fan motor?Re: Samsung RS21DGRS
Morning, the point I’m trying to make is that, is the compressor only receiving a signal for 5 seconds or all the time?
It’s more than likely the compressor, but I wouldn’t fit one without qualifying it first.
If you don’t do system work then it’s all academic really, but I’d still be checking for signal.Cheers.
Re: Samsung RS21DGRS
Hello, it more than likely wouldn’t be blocked as the motor would keep running but sound terrible.
Have you checked at the compressor to see if at the time it’s turned off that its receiving a signal?
If there’s no live down to the compressor then it’s likely to be a board fault, but if there is live there, then it’s going to be a compressor fault.Re: Liebherr CUN 3031 not cooling
Chris, if you look behind the fridge, you’ll see the white box holding the pcb by the compressor.
You’ll just need a T15 torx bit to open the box. I’ll come back to you with a part number, unless someone on here has it to hand?Cheers.
Re: Liebherr CUN 3031 not cooling
Hello chris, from what you’ve told me re the pulsing, your problem will be with the small pcb that’s housed at the back of the fridge, by the compressor.
Not sure of the part number because I can’t access tech info right now.Cheers.
