Forum Replies Created
-
Posts
-
Hello, in the vast majority of cases, the condition of the starting device is a direct indication of the condition of the compressor. Very very occasionally, you can change the starting device and fix the issue.
It seems that you have a faulty compressor, but this itself could be a symptom rather than the root cause of your problem. The faulty compressor could be because you have a leak on the system, allowing the refrigerant to escape and causing the compressor to run unchecked.
You’d need to be investigating this possible scenario, before thinking about changing the compressor to be honest.Hi mate, hope this isn’t too late. The part numbers for the 2 clips that hold the inner glass against the door are:- 0040200014 and 0040200016
Re: Sub zero
The one not cooling in the wine sections will be a leaking evaporator. Fairly common on these. There are 2 but it will be fairly obvious which one is leaking.
Cheers.Re: Whitegoods Conference 2018
It’s not allowing me to book. It’s saying Sales Ended.
Any advice?
It’s probably user error!Re: GE fridge freezer temperature problem
Hi Steve I’m not sure off the top of my head just how much the parts are.
If you do a search on this site, they might stock them. If not then AWS in Norwich sell them.
I’d get the diagnosis confirmed first though!Re: GE fridge freezer temperature problem
Hello, the likely problem here is the freezer evaporator fan. The whole unit relies on the fan in the freezer to circulate the cold air.
It’s also possible that you need a main pcb, because fairly often the faulty fan takes the board down. You’ll need an engineer who knows what they’re doing to correctly diagnose.Re: Bosch Fridge Freezer wiring help
Hi Tom, if they are the mains feed wires then quite simply the live (brown) would go to the other lives and the neutral would go to the other blue wires.
If there’s a capacitor on there, and this would be a 2 core cable with probably brown and blue wires, then don’t mix the mains cable with that.
In truth if you’re not sure, then maybe time for an engineer.Re: Please help: Leibherr fridge freezer KGB4046 24c/001
Hi James look at the bottom of the cover underneath. There may be 2 T15 torx screws there. You’ll have to pull the divider out too.
Also, roughly halfway down the cover at either side, should be little white plastic caps that come off revealing more T15 torx screws.
Be careful pulling the cover away from the evaporator as there is a connector for the fan and also sensors in there.Cheers.
Re: Liebherr CUN3033 Service information
Hi Darrell, it’s a fairly simple appliance, what do want to know?
Re: Liebherr Sbnes 3210 Biofresh temperature stuck
Hello, it would seem that all is in order!
Cheers.
Re: Liebherr Sbnes 3210 Biofresh temperature stuck
Hello, did you carry out a total defrost of the freezer? Is the drain completely clear?
b9 would be the warmest setting for the Bio Fresh compartment, as opposed to conventional thinking, where the higher the number, the lower the temperature.
I’d try the unit on a lower setting and see where it gets to. The Bio Fresh compartment should work between 0 and 2c.Re: Maytag washing machine belt
😳 Sorry guys! It is actually the pulley I need!
Don’t know where the belt came from!
Thanks for all the advice though.
Cheers.Re: Need a local vendor I can trust
Hi Helen, I think the negative reviews are indicative of the culture that we seem to be living in nowadays.
People would rather spend energy in negative ways rather than in a positive way. I think people should be encouraged to write positive reviews, obviously if they’ve had a positive experience, to counteract the negative ones.
Most of the reviews say more about the reviewer than the product anyway!
If I were you, I’d be guided by Don’s expert knowledge of appliances.
200 years of experience to take advantage of shouldn’t be sniffed at.
Don is 127 himself!
