Forum Replies Created
-
Posts
-
i would check with the manufacturer of the base to see if it has a maximum weight if that ok its a mounting problem ie its not supported evenly
as for condensation consider fitting an overhead vent with a duct fan to outside
Dave
its not a make i have ever heard of and from looking it looks like its aimed at the caravan market. dont think its a make we get in the uk as you will often get different units in Aus
unless the compressor is a 3 phase unit its unlikely to be able to alter speed. so its probably just on or off
Dave
everything is possible
have you tried disconnecting things
first disconnect all element and see if it trips
some things are more common to do this, elements as your said first, have had a fan motor do it. lampholders tend to go live to neutral so its less likely unless its been comtaminated when cleaning
are you getting any readings to earth with your meter. ?
Dave
have you checked for fault codes ?
had a few where the wires ti the front ntc broke but does not give code to customer. can only be seen in service mode
Dave
if its 15 to 20 years old it may not have a pcb
some early ones mounted the fan stat on the lamp
Dave
error sorted
try
start machine and wait till its full and starting washing
then open door and add a kette full of cold waterclose door and see if it heats
What i am thinking is it not getting enough water to operate the heater safety pressure sw. can be caused by blockages in the fill circuits on the left of the machine
other poss fault are motor blockage or damaged motor impellor
are you getting plenty of water flying round inside when its washing ?
Dave
you are half way there to replace it
you have removed the tube at one end now
turn off water and take inlet hose off
unclip the rear cover and as it comes out disconnect the 2 wires to the inlet valve
impellor can then be withdrawn from rear
swop hoses to new impellor making sure it all aligned the same and replace. dont forget to put inlet valve wires back, either way round will work okDave
can be a hard one this
As K says it could be the earth sw or it could be the element
try something
find the element connections and swop them so the live and neutral to the element change sidessee if it trips at different times
Davehave done one and from memory it was not too bad
to verify try opening the door 10 or 12 times and see if you can get it to go once to try and prove fault
Dave
is the checfk water light flashing or on all the time
if its a solid light its probably the impellor jug , the white round thin on the short hose on left of top picture
https://shop.ukwhitegoods.co.uk/424099-bosch-dishwasher-flow-meterDave
