Forum Replies Created
-
Posts
-
lots on Ebay
LNK305gn
there is one or 2 selling resistors as well but make sure they are fusible type as they dont say
Dave
yes shows you need to upgrade your fuse board. if the resistor had not acted as a fuse its likely the fan motor could get very hot. yes there should be thermal protection in the motor but its still a fire risk
An RCD device would have tripped long ago alerting you to the problem
RCD devices dont only protect against electric shock they also prevent a lot of electrical fires
Dave
does sound odd
your still on the same supply with the same resistor and the only thing the timer board does is switch itonly one thing left is an earth fault on the motor as I guess you did not add the earth on the bench, but, if you have modern rcd’s it would trip your electrics
Davelook for resistor type AC03000001000JACCS
3 watts 100 ohm the above number means its a safety fusible type
found on ebay
or
or
as for the chip would need the number off the top of it. often get them off ebay but mouser may have but just beware as am not sure of p&p or any min charges
Daveok look at the pic
check the resistor (yellow) expecting about 100 ohms
if thats gone you will need a new fusible resistor and the chip (red)
thats most likely whats failed
Dave
need to see a good picture of the electronic panel inside
it is probably the board power supply and if i saw what things look like can probably tell you what to test
Dave
often wondered how they make it a one shot device. is it a delete command in the programmer or is it done by the card somehow
must be some way of doing a memory dump off the card if you can decipher it
Dave
one of those annoying situations where you bought the dryer but don’t own software so have to buy it again
for the engineer its supplied on a smart card
dont know if its available or if your skills allow you to extract ithttps://www.hotpoint.co.uk/card-tcd980p-8kb-28686790001-j00245230/p
think its this one but do your own research to check
part no is C00278127
the smart card looks like a bank card with similar contacts
Dave
this can be useful
https://howtofixit.net/all-miele-dishwasher-error-codes-how-to-activate-service-mode/Dave
HotDog wrote:Would it be normal for this dishwasher stop start continuously on fill before it starts washing
short answer , dont know
Dave
the lower hinge is a separate part
https://shop.zanussi.co.uk/fridges-freezers/fridges-freezers/door-parts/hinge-bottom/p/8585610061030
Dave
is it still within warranty period as if you bought it on a card you will be able to get a date off that. they may have emailed a receipt and the retailer may have records as it was possibly delivered
Dave
