[Fairdeal]

Re: Indisit WIL 103

Hi John,
If you have to replace the pcb how much are you going to charge the customer? Normally the module is over £100 and then the labour is on top.and i know that indesit model is about £200.Do you think is it worth your time?

Regards

[Fairdeal]

Re: Baumatic oven

I had these problems beofre.I think when the guys who were cleaning the oven they took or tried to take the door off so that it was easy for them to clean.so it looks like just the hinges came off so you just have to put the outer door hinges in and lock it with the small catch that is on the door hing.
Hope that helps.

[Fairdeal]

Re: Need explaination on C/D parts

Thanks very much for the explainations, it has cleared my concept of these parts.

[Fairdeal]

Re: WHIRLPOOL G2PDW1/1WH DISHWASHER

Hi Mike

Does the drain pump make any noise when you close the door? if it does not then the module seems to have gone.if it does then try putting water manually to see what happens

cheers

[Fairdeal]

Re: Known Test Procedures

Quick Function Test for Baumatic BDW13/14/45.1

The following quick test procedures are used to conduct a quick test for a particular function or functions without waiting for a whole normal washing cycle. It offers a good tool to make test and diagnosis in visit to clients. The main steps and display code are as follows:

Step No.
Test Stage
Display Code
Status Explanation

00
Initiation
17
Power on; ready to run

01
Input Water
16
Input water valve on, in putting water for 15s

02
Washing pump
15
Washing pump on, 3s delay to check water
level; washing for further 10s after supply water
valves off

03
Dispenser
14
Dispenser on for 10s

04
Heating element
13
Washing pump on, heating elements on, for 15s

05
Re-generation value
12
Re-generation valve is on

06
Draining pump
11
Draining pump on, draining for further 20s after
the switch is in position

07
Test Finishing
10
Beep once, appliance stops

Procedure to enter this quick test mode:

1. Press the timer button and the power on button at the same time;

2. Then the initial stage is set with ‘17’ appearing on the LED display;

3. We can skip any step in the operating process by pressing programme button P on the

panel. And the LED display is decreased by 1 per step to 16 –15—14—13 etc to 10. The

sequence of this step is listed in the above table.

Hope it helps.

[Fairdeal]

Re: Indesit / Hotpoint dishwashers

just a point to remember.Some people actually do not rinse the plates properly that causes the filter as well as the drain and/or motor to block and hence water would stay in the dishwasher and also overflow.That is the poblem i had with few customers.Besides the indesit /hotpoint Builtin dishwashers first from left light will blink meaning the overflow as occured.

[Author]

Posts