[fasetester]

Re: Neff fan oven elements

thanks martin for the reply then this post apply to most fan oven elements not just the neff.

[fasetester]

Re: Neff fan oven elements

any one have any thing to say about this oven element thanks fasetester. 🙂

[fasetester]

Re: Neff fan oven elements

hi guys i put a new fan element in a aeg competence B4100-1-w and it is gone again in about 6 or 7 months have any of you had this problum i would like to here your reply on this and what would be the cause. thanks 🙂 fasetester

[fasetester]

Re: beko dishwasher

Thanks guy ill see how i get on 😆

[fasetester]

Re: laptop repair

thanks martin for your reply. the owner got a ticket but misplaced it but when i rung up and told them the said that should not be a problum . but would need time to look for it how long do you have to collect something is it six months thanks fasetester.

[fasetester]

Re: currys

poor tim do you have no one to do yours how sad 😆

[fasetester]

Re: currys

thanks seamy do you know the e mail address fasetester 🙂

[fasetester]

Re: zanussi fls 1183w

thanks martin and all for your help. the said the would go for a new machine as i said iwould have to check a few thing. fasetester

[fasetester]

Re: zanussi fls 1183w

thanks mike for your reply what kind of reading would you be looking for between the shorted live and netural and earth 1megohm fasetester 🙂

[fasetester]

Re: zanussi fls 1183w

the problum when first told was machine was not empying clothes wet. but after fitting the brushes. the lady of the house then told me she thought it was going throught the program very quickly so the program problum was already their.fasetester

going a bit of track when checking for low insulation. with a megger does any engineer say from a plug top ect. disconnect the module as the megger can damage the electronics fasetester 🙂

[fasetester]

Re: zanussi fls 1183w

Martin wrote:

fasetester wrote:
but then on some machines the module shuts the motor down when the fault is found does the machine just start as normal.

Yes! fasetester thanks martin.

[fasetester]

Re: zanussi fls 1183w

Madmac wrote:Would be checking motor & everything else for earth leakage, those motors seem prone to it i have found.

thanks madmac for your reply fasetester 🙂

[fasetester]

Re: zanussi fls 1183w

thanks martin for your reply reading some of the other posts. the motor most likely to give problums with taco is the zensole. is the most likely problum with the taco when it does not feed the infomation back from the motor the motor speeds up.

but then on some machines the module shuts the motor down when the fault is found does the machine just start as normal. or does any thing have to be reset to tell the module that the motor is back in action. thanks fasetester 🙂

[fasetester]

Re: zanussi fls 1183w

any zanussi engineers care to comment on this problum before i replaced the bruses. when testing on a wash program the machine filled up then when the motor would start to wash. you could here the timer click .

as if the motor signal was ok. no timer spin checked on spin program same as above. brought in water on final rinse pump kicked in but no spin program working.

then after replacing the motor brushes the problum started i think it is a cesnet motor thanks fasetester. 🙂

[fasetester]

Re: zanussi fls 1183w

thanks martin for the reply checked connections at motor. do you mean a broken wire at connector block at the motor. or broken wire going to taco or a loose taco magnet . fasetester

[Author]

Posts