[fasetester]

Re: SMEG WASHING DRYER NOT WORKING MODEL NUMBER WDI12

thanks mark for your reply . is this a intergrated appliance the lady said it was flashing a light when i ask her which she said she could not rember. then she put it on a rinse program after finshing the main wash . and it was doing nothing i ask her was their water in the machine .

she did not seem sure i dont think their was because she could open the door to get the model number . if their was a blockage in the pump would their be a fault code . if machine was complety dead could it be the door switch. are the just a interlock. thanks fasetester.

[fasetester]

Re: bendix washing machine not spinning

thanks martin fasetester 🙂

[fasetester]

Re: bendix washing machine not spinning

thanks chris i meant to say when checking with ohms scale from element and motor to earth fasetester 🙂

[fasetester]

Re: bendix washing machine not spinning

thanks for your reply. what resistance reading should i be looking for on the motor and the heating element or should i get a reading of infinity

[fasetester]

Re: bendix washing machine not spinning

are you trying to say that there is a problem with the timer?

[fasetester]

Re: LEC F FREEZER CLICKING ON OFF

thanks guys for your help so far the relay is ok i am going to change the capactor i cant see the rating on the capactor. could you please tell me what capactor i should use uf rating the compressor is a TLEs6F thanks fasetester.

[fasetester]

Re: LEC F FREEZER CLICKING ON OFF

thanks subs for your reply. how do you make up a test. lead would a blockage in the lines cause this. like a back pressure the compressor goes to start then it shakes and stops. thanks fasetester 🙂

[fasetester]

Re: LEC F FREEZER CLICKING ON OFF

only getting back to you now my neice died why would their be a capactor connected across the relay it seems a bit strange is their any way to test a dandyfoss relay it looks ok not burned thanks fasetester

[fasetester]

Re: LEC F FREEZER CLICKING ON OFF

thanks sims for your reply i should get a reading across all the pins on the compressor. what reading should i get. and is there any way to test the relay. is there a over load on the relay. if it is tripping out what would cause it. thanks fasetester. 🙂

[fasetester]

Re: samsung ff

does no one have any infomation on this ff it is near a week from i posted what is the most likely cause thanks fasetester 🙁

[fasetester]

Re: Domestic Appliance Testing

hi martin could you please send me the info on testing thanks fasetester 🙂

[fasetester]

Re: hoTL 61 point dryer

thanks guys for your reply. i was repairing another appliance and he just said it was in the shed. it was late on and a lot of thing in front of it i thought that when i went back i would be prepared if the copper strip is worn throught does it not need to be replaced.

or was it the jocky pully if makeing a noise to put some grease on. is it a successful repair. putting the bearing kit in these dryers. not like the proline creda dryers. thanks fasetester 🙂

[fasetester]

Re: samsung ff

hi guys and girls no one have any advise. what to check where is all the fridge freezer engineers. fasetester 🙂

[fasetester]

Re: creda bearings

thanks guys for your reply when checked out it was the bearings in the motor . can you still get the armature and the bearing as a kit. thanks fasetester. 🙂

[fasetester]

Re: creda bearings

not sure guys the only number that the could see was17110 does the front split on these thanks fasetester

[Author]

Posts