Forum Replies Created
-
Posts
-
Re: washing up liquid in GDA dishwasher
thanks guys for your reply went to look at dishwasher the woman said it is not heating and keep running. wont stop their still seems to be some foam in it cant get it on rince program. for it to pump out .
checked heater and 3 stats in the door the are all open and closes when heated the heater is ok. it just keep washing no heat and wont move in cycle their is a timer in the bottom at the front.do you have to move the timer by hand to get it to heat and rince. and when you hang the wooden door and get the screws in at the top it comes out the bracket
retainer at the bottom the inner panal seem ok all screws in place fasetester
Re: washing up liquid in GDA dishwasher
well guys and ladies no one have to sort this out before little help would be greatfully accepted thanks fasetester
Re: smeg w/d click around end of program
thanks mark for your reply. what does the spanner symbol mean can it be put into a test mode. fasetester
Re: smeg w/d click around end of program
this post has gone quite are you all on holidays 🙁 fasetester.
Re: smeg w/d click around end of program
well ladies and gents no one have any pointers what to check. fasetester 🙁
Re: smeg w/d click around end of program
well guys and ladies no one have any advise where all the smeg engineers . 🙂 fasetester
Re: Using Search facility
guys i do use the search before i post. i put in the name type model fault and where i want to search most the time it does not come up with what you are looking for. what am i doing wrong. thanks fasetester
Re: SMEG WASHING DRYER NOT WORKING MODEL NUMBER WDI12
thanks mark for your reply. when you check the interlock on resistance scale on meter should you not get a closed circuit between the first terminal on the right and the common. when you close the interlock with a screwdriver and between common and N fasetester.
Re: SMEG WASHING DRYER NOT WORKING MODEL NUMBER WDI12
well guys i went and replaced the on/off switch put all togeather switched on machine starts to fill then in about 30sec nothing. 13amp fuse gone and 30amp in consumer blowen as well.
machine sitting half full of water remove hose and empy water. still door wont open have to work at interlock to get the door open. disconnect wiring take note of where each wire is connected.
check interlock from first terminal on right close lock with screwdriver should i not get a close citcuit across the switch to last terminal on the left.
this is the wiring on interlock twin red from first terminal on the right this one does not seem right the next terminal over to the left which is the N on the switch to the heater is a twin brown and the last one on the left where the switch closes is a pink wire i dont know if anyone was at the machine before me.
when i connected the hose up for the water it sprayed all over the place the lady said some one brother or husband said the hose was kinked so i put on a new hose . any thoughts or help welcome thanks fasetester.
Re: smeg WDI12
thanks tim for your reply would the hotpoint switch or new wave switch clip in to the front panel ok you have to modify the switch to fit the button . would you have a part no for the hotpoint and newwave switch i have got attchment from servevast could any one tell me is this the part no for on/off switch 23785 thanks fasetester.
Re: SMEG WASHING DRYER NOT WORKING MODEL NUMBER WDI12
thanks mark for your help does the on/off switch just clip out of the front panel . fasetester
Re: SMEG WASHING DRYER NOT WORKING MODEL NUMBER WDI12
thanks mark and canufixit for your help it seem like the on/off switch when u push down on it it works where the best place to order a switch. and how does the front switch pannel come off.
does the timer knob and the other knobs just pull off thanks fasetester 🙂
