[fasetester]

Re: creda condenser dryer modTCR2

Martin wrote:Then work should be concentrated on that condenser channel and pump. Also I seem to vaguely recall these heaps of junk have problems with the float microswitch, so check that out too. 💡

went back to dryer checked opening at back of condenser it was OK. checked micro sw pump was running does the pump on this dryer run all the time.

good air flow give condenser good hosing told the person that the need clean filter after every drying cycle and condenser ever 6 week or so thanks martin. fasetester

[fasetester]

Re: creda condenser dryer modTCR2

Martin wrote:A few months down and back to square one eh fase?

Did they ever replace that damaged lint filter you mentioned a while back? Is the channel from the condenser matrix to the pump blocked again?

I’ve no idea what the temperature is inside the drum (bloody hot I expect) but around the temperature of the cycling stat anyway (whatever that is 120c maybe? Dunno)

yes martin new filters dryer does not extract water through condenser drum heating but not drying clothes

[fasetester]

Re: creda condenser dryer modTCR2

though had this dryer sorted got a message to say dryer heating but not drying clothes no water in drawer there is no water getting to pump chamber condenser not producing any water.

could this still be a problem with condenser what temp should the dryer be inside the drum to dry properly thanks fasetester

[fasetester]

Re: hoover HDB244 door not opening

the machine or the person martin LOL fasetester

[fasetester]

Re: hoover HDB244 door not opening

Martin wrote:I just checked and it’s the old push button/ Bowden cable job fitted on these old Candys. But I expect you’ve found that out by now and sorted it. 😉

thanks martin for your help went to machine nothing wrong with machine door opened first time even after test don’t know what was wrong with the person fasetester.

[fasetester]

Re: hoover HDB244 door not opening

Martin wrote:Lift the lid, access from the top as is often the case. As to what is wrong then I thought the answer obvious. Don’t you think?

it mechanical operated button do the break or just stick fasetester

[fasetester]

Re: creda condenser dryer modTCR2

after cleaning condenser dryer still not heating drum properly how do you get to ducting on this dryer to check for blockages and is their a fan to blow the moist air to condenser thanks fasetester.

[fasetester]

Re: creda condenser dryer modTCR2

Thanks Martin and andy prob blocked condenser as the were using the dryer with damaged filter screen fase tester

[fasetester]

Re: buying clamp meter

thanks martin for your reply have seen your guide fasetester

[fasetester]

Re: buying clamp meter

martin the model mastec ms2008B fasetester

[fasetester]

Re: 8 Week old Transit

sorry to see and here that your van is destroyed but glad to here you are not injured. fasetester.

[fasetester]

Re: beko wme8227B

thanks seamy fasetester

[fasetester]

Re: beko door seal wme8227B

thanks don fasetester.

[fasetester]

Re: beko wme8227B

thanks for your reply seamy is their any knowen cause and cure for burning and smoking fasetester

[fasetester]

Re: beko wme8227B

yes seamy is their much room to get the band on going throught door. i was reading some post where the new seal rubs on the door is this one of them. any tips on fitting spring thanks fasetester.

[Author]

Posts