[fidder]

Re: NEFF C57M70N0GB microwave

No Error codes

[fidder]

Re: MIELE NOVOTRONIC T220 TUMBLE DRYER NO HEAT

if heater ok then more than likely…its the PCB board

[fidder]

Re: Miele T490 tumble dryer

Hi…I am a ex Miele eng…and now independent….its the PCB board…needs changing…about £80 + vat…Iv’e had a few of these now.

[fidder]

Re: LG Washing machine

Sorry…the pump does not run at all. No blockage.

[fidder]

Zanussi ZWD14270w1

Hi Guys
I have a zanussi ZWD1427OW1 that just will not start.
You can select program, select spin speed etc, light comes on and flashes to push for start, push start and green start light stays on,door is locked ok, window show time left to go in wash and counts down..no drain pump noise or hum… it does nothing else..no water intake, no drum action…just nothing.I forgot to say…drain pump does not even attempt to start.
Any ideas would be welcome

[fidder]

Re: MIELE W308 WONT SPIN

have you checked tach gen for voltage output?
you may also have a broken wire in loom…check
Does it show any fault code?
Fidder

[fidder]

Re: Miele error codes – can you or can you not reset them?

Q. does the fault indication on Miele machine flag up when customer switches machine on after fault has been cleared?
Awns. Categorically NO!
But it will stay in memory till an engineer clears it.
Hope this helps. 😉

[fidder]

Re: Miele error codes – can you or can you not reset them?

Hi to all
Just a note to say thanks for the forum…very interesting remarks.
as for hefty Miele repairs…the only time there is a probability for BER is when the motor or electronic is U/S…but this is very rare in my experience.
New machines either come with 10year warranty or 2 years on all parts and labour. The other way around the problem is to leave an estimate(chargeable) and tell customer to try for D&G insurance…this of coarse lowers the cost considerably.
Good luck felllers… 😆

[fidder]

Re: Miele error codes – can you or can you not reset them?

Hi Andy… I do service work for them and was a miele engineer. I work on all the new models and I can tell you that it does not matter about faults in memory…its only for info for engineers. They can be reset manually…but we do it via the laptop and what is called an MDU unit which tell you all.
clear the fault and hey presto…it all works again…clearing the fault code only clears info but defeats the object of knowing what the machine faults have been…hope this help…let me know if you get stuck on anything.. :rolls:

[fidder]

Re: Bosch WAE24363GB

Thanks so much Nomadpaul…thank goodness for UK Whitegoods it the best. I f you or any one needs any info on any Miele machines both com/dom I would be glad to help…we have all the info…
cheers.

[fidder]

Re: Bosch WAE24363GB code F21

Its a machine I am going to…the fault reported is F21…I did not want to go in without knowing the code. 😆

[fidder]

Re: Bosch WAE24363GB

Have tried that..still no solution…

[fidder]

Re: Miele Novatronic W1512

Try removing the water re stricter inside inlet valve..that should give more volume of water

[fidder]

Re: Whirlpool awm9000 washing machine

I did not think there was brushes? induction motor is it not?

[fidder]

Re: Bosch SPS 546 Dishwasher

if motor turns…check to see if there is a start capacitor nearby..fidder

[Author]

Posts