[Galway]

Re: Whirlpool D/W F06?

check that reed switch is sitting in right position and that connections are good.if reed switch is visable on this model then if can easily be replaced.
Niall

[Galway]

Re: siemens D/W detergent left on glasses

not taking in enough water?try cleaning pressure chamber

[Galway]

Re: The Fault Code Guide

àny date yet for android app?

[Galway]

Re: beko dcrs 68 stopping

if you have a clamp meter you can how much current it is using
in test mode against the element rating.other than that module i would think.maybe ewm miight be able to test it for you and supply one if it is gone.

[Galway]

Re: beko dcrs 68 stopping

did all or half the element come on?if it all came on then i would be looking at the module

[Galway]

Re: electrolux erf2620 fridge/freezer

fan had stopped running but a push got it running but as a matter of interest how would you replace the fan on this one?
thanks Niall

[Galway]

Re: creda oven R430ER

come to think of it the hinge on that side of door is not sitting properly so you are prob spot on
thanks Niall

[Galway]

Re: creda oven R430ER

the thermostat light stays on so i am presuming the door switch is ok?

[Galway]

Re: beko dcrs 68 stopping

check element and sensor inside door?there is a test program on here somewhere

[Galway]

Re: whirlpool adp 7408 d/w

finally got part and fitted it
job done.
this part fits where the old type vacuum level switch fits in the sump.not exactly sure how it controls the water level as it is solid plastic but has lenses, but it also acts as the ntc as it has a probe for temp.

[Galway]

Re: Miele W970 Washing Machine – check inlet warning problem

hi
the piece you are trying to identify sounds like the element holder/guide.

[Galway]

Re: zanussi zdc37200w

there is usually a stat in the front also.not sure of this m/c but open the door and head in and look up usually on front of m/c
or if you are unlucky you may have to dismantle the front.

[Galway]

Re: Prima lpr600/1 error code 6

if this is a “whirlpool in a dress” dishwasher this fault could also indicate a flow meter fault .if water starts to enter machine and then it stops and fault appears then check the flow meter t may have moved slightly.

[Galway]

Re: Hoover Washer dryer 1300 HNW 7137 S/N 09858 Not drying

hi Hilary,
not familiar with this exact machine but this could be a number of things
1/blocked pump/filter
2/condensor solenoid
3/timer/module/broken wire
if clothes are hot and wet i would think that the dryer element is ok .the machine sounds like it is not draining the water while trying to dry.?
good luck
Niall

[Galway]

Re: whirlpool adp 7408 d/w

found the part no. 484000000420
it is a blue switch owi + ntc probe all in one.
anyone know if these give problems?

[Author]

Posts