[garn]

Re: CANT FIND THIS MODEL DIPLOMAT ADA 8541 DRYER

hyg-dip wrote:I guess the correct model number is ABA8542, we have the spares in stock at AWS Appliance Spares on 01603 412324 or sales@awsappliancespares.co.uk

Thanks Mate .
It Was A Tel Inquire By A Reguler Customer For A Self Fit.

Just Given The Customer Your Webb Address And Phone no IF Thats Ok 🙂

Thanks Paul…

[garn]

helo_75 wrote:41020376

is the number listed on gias tech site

hope this helps?

The Same One The Connection tabs Are On 45{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}.
all DONE MATE Your On The ball 😉

Garn..

[garn]

Re: Can Any One Give me a Model Info hvr Oven

Thanks h

CANT Seem to Find The Correct Element my parts distributors Are Only Showing Three Turn Element
The One I Pulled off has Only 2Turns And The Ones i have On The van Are Slightly To Small.

garn…

[garn]

Re: SIMPLE PCB REPAIR TIPS

Hotpoint Indesit Board Faults
Symptoms

Continues Pumping Out 😕
Continues Filling 😕
machine Doesn’t Start up Dead 😕
cant Select Diagnostics. 😕

You may Find After Checking The taps. ntc. Pressure Switch. motor Windings. Door Lock.
You May Find After Checking All That Its Still Knackered :rolls: .
These Days i go Strait On To The Board With The best Cure You can Find.
A Sowing Needle

Carefully Lift Those Connections up With The Needle.

Warning if You Raise Them up To far The Connection Will bend As You Fit The block onto The Board When This happens Your Original Fault May be Mended 🙂 And You may Find Another Extra Fault One of The Above 😥 .

have Some Patients 😡 And Start Again
Lately I have had A lot of Success on A mend With Theses Symptoms
All Indersits HPT. Wml . Wt .And So on The Appliances Are All About 2to3 Years Old. Must be Down To All That Rattling About.

Garn…

[garn]

Re: Hoover Oven no Identification On Model

Penguin45 wrote:http://shop.ukwhitegoods.co.uk/Cooker+{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}252526+Oven+Parts/Candy+Spares/Candy+Fan+Oven+Elements/Candy+Cooker+Oven+Fan+Oven+Element.html?osCsid=b5ce2e7467f1a413c7d8ce2d0ce610b1

That’s the common one, but it’s a guess.

Chris.

Cheers Chris It is A Common one The One i had On The Van Are a Bit Short.

[garn]

Re: Currys tech guys cleaning service

Myself before I Finish A Job I Always Give A Service clean On The Appliance. its Always Been Part Of My Service.
By The Time Iv Finished The Customer May have Bought A Cleaning Service Pack That i Carry on The van. Microfiber Cloth A 10month pack Of Descaler And A Hoover Flexetool. u can make an Extra£15.00 Profit 🙂

Mind you The Hotpoint Descaler Pack price has Gone Through The Roof
And The Cloth. Now I’m using The Electrolux Stuff. Good Thing About There Descaler You can Take The Bottles home And refill Them From The Tesco Stuff You Can Get 4 Bottles For Less of A Price Than One 😉

Mr Cleaneasy Man 😉

[garn]

Re: DESIGN AIR COOKER HOOD

don wrote:This hood I presume from B & Q @ £149 for a 90cm chimney just has to be an import from the Far East 😉

Don

Yes don b&Q.
Just had The Info From There Service Dept The part Is The Switch Includes The fan Speed Control £13.00 + Not A Bad Price 🙂
we Are Still Going To See If They Will honor The Guarantee The Guy Is Using The Trading Standard Effect :rolls: And Its made In Taiwan.

Chears paul

[garn]

Re: Invoicing and customer record software

Natwest Business Software very easy To use even calculate Your Tax . Print Your Invoices Has A Total Customer Database.cant Lose Nothing Complete Service back Up.
Free for The First Two Years After That £50.00 Well Worth it. And You Dont Have To bank With .

garn…

[garn]

Re: DESIGN AIR COOKER HOOD

loaf wrote:Try Elica /D R cooker hoods

http://www.elica.co.uk/

No Luck im afraid 😥

garn

[garn]

Re: service M685W TEARING CLOTHS

Penguin45 wrote:Mix your synthetics in with your cottons and put ’em on a cotton wash will usually rip stuff to bits.

Chris.
That’s Interesting i do all The Washing And Drying :rolls: In The House.
Never Mix Them Myself. The Only Thing The Mrs has Got A Nasty Habit Of Dumping The Bedding on The Floor In Front Of The Machine Late Afternoon And Then I’m Stuck Till 9pm Drying The Stuff. 😉
Thank God For The Hoover Nextra It has Excellent Quick Washes

TA paul…

[garn]

Re: service M685W TEARING CLOTHS

spimps wrote:Bra wires often pop up through the holes and do that.
Shining a torch through the drum might ID one.
Front seams used to split but haven’t seen that lately.

Cheers mate There Was no bra wire There. Doing This One Over The Phone With my Mate :rolls: he Is A electronics Engineer But he has No hand Skills At All He Pulled his Zanussi to bits he Once just Didn’t now about The Front filter And the Trap..

chers Garn…

[garn]

Re: Welcome The Amica Trade Support Forum

BDC have Stock There http://www.bdc.co.uk Haven’t Bought From There For A While not Since My Local Driver Said This Was his Last Drop He had been There For Years Cardiff branch.
Then They Went a Bit Dodgy after That.

Iv Tried To get In On Line . Could Only See To Indersits For Sale
But I Had There Buyers Guide Delivered Out Of The Blue last Week And It Shows A Complete Range Across The Board

Paul

[garn]

Re: Welcome The Amica Trade Support Forum

Thanks For The Membership.

Its Nice To Feel Exclusive For A Change 🙂

I Will Say Iv had A Very Good Feed on These Amica Appliances Since 2008
Not one Bad Word or A Doubt And There very OAP Friendly And reasonably Priced And reliable.

Over The Moon Paul… 😉

[garn]

Re: Waste Carriers Licence

As a trade we’re doing the ‘environment’ a favour by recycling machines.

I had A argument With A local Allthoraty rep. i Said The Same as bagman.

his Reply Was that I was Not Recycling Only Prolonging The life Span of The Appliance for A Short Time. Its Coming Hear Anyway. my reply Was There Are a Lot Of people Who just Cant Afford A New One Through No Fault Of There Own. he Was Not Interested .The Company Who Takes These Appliances from The Local Authority Are Making Millions The Guy Who Owns This Business Used To Drive A discovery now he has A Lexus.

Example 50{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of All wm in The Tip have Nothing Wrong With Them or Miner Faults ( Pumps Brushes And A De gunk)
Somebody’s Mrs Wants A Silver One Instead Of A polar one and In A year They want To Change To A Black One.

Gone Are The Days You Can Refurb A hpt wma Wf Wt Wml The Price On The Parts have Gone Through The Roof ( rear half Spider door Boot And Carbons) Your Nearly In to £90 Before You Start.
The Customer replies I Can Buy A new one for £149.00 In Argos 😡 .

Even The New hopoints are noisy I recon They Should Supply Them With A Built In Dab Radio just to Drowned The Roar Of The bearing Out 😆

[garn]

Re: Tips, Tricks & Shortcuts

Iv Always Used A Dab of White Grease To Coat The Bearing & Seal When Replacing.

the Past Couple of Years Iv Been Using The Aerosol Type Much Better. And You Can Coat The Bearings Inner Sides When Fitted makes A Real Difference When You Give it A spin.

Also If You Are Using The Original Spider it Will Prevent That Tear Drop Drip you may Find Coming From The Drum Weep hole 😥 After Putting The Thing Back Together 😉 .

Iv Tried The Wynn’s Product To Thin Does not Stick Very Well.
use The 3in1 Oils Product That The best £2.99.

Garn…

[Author]

Posts