gegsy

Forum Replies Created

Viewing 15 posts - 1,726 through 1,740 (of 6,724 total)
1 2 3 … 115 116 117 … 447 448 449
  • Author
    Posts
  • September 13, 2007 at 5:07 pm in reply to: further enquiry about neff dishwasher #227520
    gegsy
    Participant

    Re: further enquiry about neff dishwasher

    Hi
    Could be faulty module or crud build up in the level sensor unit on the left hand side of tank.

    Please do not LIVE test under any circumstances.
    Power off if you are to investigate this fault

    Greg

    September 13, 2007 at 4:51 pm in reply to: Bosch WFL2260GB/01 #227481
    gegsy
    Participant

    Re: Bosch WFL2260GB/01

    Does it heat? they will continue through cycle to the END even in fault,and do take around the time you are getting also under that fault condition 😕

    Greg

    September 13, 2007 at 4:45 pm in reply to: washing machine not spinning #225570
    gegsy
    Participant

    Re: washing machine not spinning

    Its in the base near motor but at approx £175 + and the motor approx £158 + the usual you better be sure which are at fault 😯

    Greg

    September 12, 2007 at 10:44 pm in reply to: whirlpool leaks #227460
    gegsy
    Participant

    Re: whirlpool leaks

    Replace top of dispenser, job done 😉

    Greg

    September 12, 2007 at 8:46 pm in reply to: freestanding range recommendations #227447
    gegsy
    Participant

    Re: freestanding range recommendations

    or even Falcon, very good quality.

    Greg

    September 12, 2007 at 8:45 pm in reply to: rangemaster 110 #227311
    gegsy
    Participant

    Re: rangemaster 110

    Lawrence wrote:But they did sell the leisure brand to Arcelik and I have seen a leisure which is actually a Beko

    What a joy they are :rolls:
    Not as nice as the old Leisure to get into.
    Usual faults overheating mains terminal and dreadful thermal fuse failure rate.

    Greg

    September 12, 2007 at 7:03 pm in reply to: washing machine not spinning #225568
    gegsy
    Participant

    Re: washing machine not spinning

    Module=PCB the circuit board

    September 12, 2007 at 5:38 pm in reply to: washing machine not spinning #225566
    gegsy
    Participant

    Re: washing machine not spinning

    Hard to say. Module may have been damaged with original fault, or motor damaged by original fault. 😕

    Greg

    September 12, 2007 at 5:36 pm in reply to: NEFF OVEN #227149
    gegsy
    Participant

    Re: NEFF OVEN

    Hi
    Can’t see that module anywhere on it 😕
    The module 264472 comes as 2 parts connected by ribbon cable.
    The main part of it accepts the knob and engages the rotary selector unit on PCB (the knackered bit) 😉

    Greg

    September 12, 2007 at 2:03 pm in reply to: Bosch WFK2200 My bleep’s come back #227369
    gegsy
    Participant

    Re: Bosch WFK2200 My bleep’s come back

    If its adjustable it will be in your user manual. Don’t have one to hand sorry

    Greg

    September 11, 2007 at 9:09 pm in reply to: NEFF OVEN #227147
    gegsy
    Participant

    Re: NEFF OVEN

    Hi
    Module only sure fire way of curing, p/no 264472 app £140+ the usual.

    Greg

    September 11, 2007 at 8:52 pm in reply to: Bosch SGS6962GB/13 dishwasher 199 minute wash!! #227337
    gegsy
    Participant

    Re: Bosch SGS6962GB/13 dishwasher 199 minute wash!!

    Hi The 55/65 is usually an “Auto” setting which basically it relies on the aquasensor or turbidity sensor to look at the water quality and adjust the wash times accordingly.
    If you had a heating fault you would get an error code 2 in the display.

    HGreg

    September 11, 2007 at 8:46 pm in reply to: Bosch integrated condenser dryer WTE6920 #227348
    gegsy
    Participant

    Re: Bosch integrated condenser dryer WTE6920

    Well its steam from somewhere 😕
    Have you checked teh uplift pump assembly from start to finish for obstruction?
    If the drawer is used, where the hose enters the dispenser (top rear), remove and look for any lint blockage.
    Remove uplift pump as Ive seen a ball off fluff jam the poor impeller 😉

    Greg

    September 11, 2007 at 7:50 am in reply to: siemens wtxl1100gb/01 fd8410 part no 496079 #227272
    gegsy
    Participant

    Re: siemens wtxl1100gb/01 fd8410 part no 496079

    Hi
    BSH list it as 50.40 GBP
    Im sure this appliance is made by Gorenje :con:

    Greg

    September 10, 2007 at 8:18 pm in reply to: neff/bosch motor end frame #227188
    gegsy
    Participant

    Re: neff/bosch motor end frame

    I can only comment on what manufacturer says fit TBH 🙂

    Greg

  • Author
    Posts
Viewing 15 posts - 1,726 through 1,740 (of 6,724 total)
1 2 3 … 115 116 117 … 447 448 449