[gegsy]

Re: Indesit Dishwashers and their Problems

Well you did give us Neighbours and Rolf Harris 😆

[gegsy]

Re: neff u1420w0gb/02 oven door handle broken

As far as i know
Once you have taken screws out of handle, the glass will prise away(gently) from the main metal door frame at the top.
Then gently seperate the two in an upward motion as the clips bonded to the glass, hook onto door hinges.

Hope that helps

Greg

PS do it on the floor for obvious reasons 😀

[gegsy]

Re: Best Washing machine!

:tup:

Is also future proof by upgrade via Miele engineer and laptop.
Is closer to £500 than £400 but is an excellent choice.

Greg

[gegsy]

Re: Suk90mfx – not heating properly in Fan Mode

Hi definately a Smeg 90cm dual fuel range.
Has twin fans and elements in the one cavity.
Suspect one element has failed giving the low temp.
The elements are changeable from the front with care ie- that you don’t lose the wires off the element when you extract the elements.

As always unplug the appliance :plug:

Regards

Greg

[gegsy]

Re: Matrix Dishwashers?

Hi
Had the pleasure of working on one of these today.
Customer used it for 1st time and blew the trip.
Heater unit u/s.
It looks like a cross between haier,smeg and ariston (lovely blend…NOT)

Greg

[gegsy]

Re: Matrix Dishwashers?

Original script read Dishwasher and not Matrix

Greg

[gegsy]

Re: smeg suk91mfx fan elements

I would imagine 1 element went then the other.
They are both independent and not linked together.
Job can be done from front, so dont get a hernia pullin it out 🙂

Regards

Greg

ALWAYS PULL THE PLUG BEFORE ATTEMPTING ANY REPAIR :plug:

[gegsy]

Re: Carbon brushes for Bosch washer

Hi
Sorry but that is correct. Only snag is you have to split motor to gain access to brush assembly.

Sorry

Greg

[gegsy]

Re: Siemens SIWAMAT 6102 Error Code 2

Hi
Error code 2 is a heating fault.
If you going to check heater (app 30 ohms) always pull the plug :plug:
Also with the age of appliance its not uncommon to have the empty pump intermittently jamming causing error 3 :plug: again.

Regards

Greg

[gegsy]

Re: Siemens SIWAMAT 6102 Error Code 2

Hi
Please supply model number off rating plate usually around door.

Enr or Fnr and FD

Thanks

Greg

[gegsy]

Re: Miele G575 problems

Thanks and noted. this is what we all about because knowledge is power

Regards

Greg

[gegsy]

Re: Siemens SE24200 – intermittent electrical problem… HEL

Hi
Any BSH agent would have access but as to releasing them I would imagine it would be a negative as all BSH information is only available to agents and comes with an annual fee

Greg 🙁

[gegsy]

Re: Reasonable Delay?

Hi
For merloni I think this a record repair time 😆

Greg

[gegsy]

Re: Siemens SE24200 – intermittent electrical problem… HEL

Hi
Just to put you in the picture
I have NEVER had a loom problem with the “new” type of bosch,siemens or neff dishwashers.
I have never had the “new” type of interlocks on said dishwashers faulty either.
The only similar fault I have had to yours was when the dishwasher was pushed hard back against plug top at rear and glued itself to tar like insulation.
When appliance heated up or moved it would dislodge plug from socket and cause similar fault to yours

Greg

[gegsy]

Re: Bosch Maxx 100 washing machine wash out failed

Hi
If you have low cold water pressure, the conditoner part will not work due to the design (2 valves operating and coming together at a point in dispenser thus operating conditioner unit)

greg

[Author]

Posts