Forum Replies Created
-
Posts
-
Re: Spin not drying very well ?
Just to add………….
When you say ” Spin a wet towel on 1400″, are you just using the spin setting and not a wash cycle? If so that setting is a reduced spin speed 😉Greg
Re: Another joke.
A man appeared before St. Peter at the Pearly Gates.
“Have you ever done anything of particular merit?” St.Peter asked.
“Well, I can think of one thing,” the man offered.
“On a trip to the Black Hills of South Dakota, I came upon a gang of bikers who were threatening a young woman.
I directed them to leave her alone, but they wouldn’t listen.
So, I approached the largest and most heavily tattooed biker and smacked him in the face, kicked his bike over, ripped out his nose ring, and threw it on the ground. I yelled, “Now, back off, or I’ll kick the shit out of all of you!”
St. Peter was impressed .. “When did this happen?”
” Couple of minutes ago.”Re: Bosch sgs43a22gb/01 flood protection
Hasn’t got one 😉
My bet would be on a sticking float.
If you remove the filters and look at the 3 oclock position, you should see a cap, remove that and in there is a float capsule with a magnet on one end.
Remove it and clean it and its housing making a note of the orientation of the float and then re assemble. 😀Greg
Re: OVEN IS DEAD – NEFF B1641
Hi Gregg
If you can post the full model number off the appliance itself and advise which oven your wife was using when it went pop, that would aid us greatly 😀
It may just be an element that has popped, some do, some go quietly 😉
Un plug appliance if you are to investigate :plug:Greg
Re: Barclays Premier League 2007 – 2008 / Champions League
Spurs were better team but Walcotts goal was a good one, If it had been Adebayor the keeper would have played catch 😆
TV and radio pundits are so anti Arsenal anyway I dont bother listening 😀Greg
Re: Responsibility.
But if Martin isn’t going to post in Public Forums anymore, surely this is going to leave it open to non moderation of potential dangerous posts if he is the only mod online :con:
Greg
Re: teka d/washer
Hi Chris
A 4mm socket will do the job 8) 😀
Oh, as for drain pump, r/h panel off and just remove the three torx holding main pump body onto housing is easier than trying to get at the one screw on housing, stupid angle 😡
GregRe: smeg dishwasher power loss
smegging-hell wrote:thanks for the responses. can anyone tell me where i’ll find the model number? mucho thankyous.
Usually on a sticker on the left or the right of the door inner side.
Greg
Re: rangemaster 110
Hi
May I just point you here http://tinyurl.com/2obv8n
Also I would not use the appliance until a gas qualified engineer has checked it out thoroughly ❗
Please feel free to use our repairs@ service from the left hand side links 😀Regards
Greg
