[Geoff1312]

Hi Dave , thankyou for your help . I’ve told her to get on to Argos as per usual she wants it done yesterday so It ‘ ll be more trouble than it’s worth
thanks again
Geoff.

[Geoff1312]

thanks Dave, the whole ring doesn’t shut down just the centre coils, but i will check and see if they’ve recently got new pans . thanks again.
Geoff

[Geoff1312]

Hi Dave . That would be great : sdas.binfield@btinternet.com many thanks Geoff.

[Geoff1312]

Hi Dave , thanks for your reply. i’m sure they were all flashing , may have to have another look , but if all flashing what does that signify?

[Geoff1312]

The existing regulators and replacement ones are ego but with more tags on the new one.
The existing was a 50. 52021.010 with no s1 and s2.
The new one is a 50.55021.100 with the s1 and s2 present.

Thanks
Geoff

[Geoff1312]

Sadly no it’s a gas hob. I’ll go back with all this new info and hopefully resolve , may be a faulty switch , fingers crossed thankyou .
cheers Geoff

[Geoff1312]

Hi Dave , foolishly didn’t take photo . Did double check mod. no. Will have to go back and try again , just thought if I could track down diagram would make things easier as i would have cable colours. I couldn’t find model either but connections managed to find it and old switch is a 43ER101C1 and apparently they are compatible , thanks for your help.
If it was easy everyone would do it.
Cheers Geoff.

[Geoff1312]

Hi Dave don’t think it has a pcb fan control but can’t get a parts listing , had to put in a pne to get grill reg number. If i could find the fan control contact i could probably sus it out . If it has a pcb control it’s ok cos if i remove link wire fan stops.
Regards Geoff

[Geoff1312]

Tash / thanks for your reply , what did you do?

[Geoff1312]

Thanks Dave, I’ve seen this if i could get a diagram i could identify the cooling fan cable and hopefully sort it .

[Geoff1312]

Hi Murv this is exactly the machine i went to . Thought Indesit had made a cock up and forgot some bits. How on earth do they expect that to condense the steam ? Not much I can do as everything else is fine, not a very old machine . Elderly cutomer is gonna try it again fingers crossed . Thanks for your reply Geoff.

[Geoff1312]

Thanks as always for the info Dave . Geoff1312.

[Geoff1312]

Re: AEG F34030V10 3 flashes.

Hi Dave.
PNC is 91153904605 there is no waterin the base and float and switch are functioning ok.
Regards Geoff.

[Geoff1312]

Re: bosch dishwasher e19

Thanks Steve will try what you say . A new valve isn’t too epensive so may go down that route , thanks again .
Geoff.

[Geoff1312]

Re: bosch dishwasher e19

Hi called to dw today details are: enr smv58l00gb/35 fnr 00606 fd 9508. On examination valve between heat exchanger and tub is o/c could this cause e19 and how after replacing do i clear the fault ?. Thanks in anticipation Geoff 1312.

[Author]

Posts