[gramp]

Re: hotpoint vtd60p tumble dryer motor stops after 30-70 min

yes i am in the trade

[gramp]

Re: vtd60p motor stops after 30-70 mins

sorry hotpoint vtd60

[gramp]

Re: candy DFI 45 Stopping

cheers Penguin45
will have to think this over and decide where to start

cheers again gramp

[gramp]

Re: cna spares

cheers Greaseater
will give them a call in the morning

[gramp]

Re: hotpoint wt761g no spin

yes tried it with nothing
pumps fine just no increase in speed at any part of spin cycle

[gramp]

Re: indesit door locking

yes thought as much didn`t think it could be anything else
thanks for your input

[gramp]

Re: new world oven hinges

thanks for the input

the hinges are a complete unit one each for top and bottom as door opens to the side

[gramp]

Re: beko wma510w

i have looked at 2 of these this last week with same problem and landlord is thinking of going ahead with the pcb change .
but reading your replies i think i will advise against this .
thank for any input

[gramp]

Re: servis m6006w no start

all sorted but a bit dodgy sevis engineer said it needed to be reset but they would give her a new machine. sounds very strange to me if it only needed to be reset.
thank everyone for thier help

[gramp]

Re: servis m6006w no start

ok thanks for your help but friend has found her receipt and service engineer calling tomorrow.
again thanks for your help
alex

[gramp]

Re: servis m6006w no start

have tried that a few times .no joy
thanks for reply

[gramp]

Re: bosh wfo2865uk/01 time display jumping to end

was working fine then didn`t empty .drained then then found some items in pump.put back on to spin 11mins counted down to 8mins then jumped to 1min .then changed brushes.
when i tried on rinse filled to right level

[gramp]

Re: bosh wfo2865 time display jumping to end

enr wfo2865uk/01
fd8311
601386

sorry had entered a zero instead of the letter o

[gramp]

Re: INDESIT WIDL126 ERROR flashing

thanks penguin 45 that was my worst fear . just could not find list of faults

[Author]

Posts