[hilly]

Re: hotpoint FDW60T d/w

been back to see this one i took a pcb just incase but it didnt cure the problem circ motor still contiuously running ive checked all hoses just incase of blockages but all clear any more ideas cos im baffled 😕 😛

cheers paul

[hilly]

Re: hotpoint fhp motor

thanks for advice, found tacho wires chafing on motor body, ive insulated them not heared anything from customer for a few days so fingers crossed i must have been unlucky with my choice of second hand motors (its very rare i use second hand bits cos they can be too mush hassle as this experience reminds me)

cheers paul

[hilly]

Re: hotpoint FDW60T d/w

cheers iadom, filters all clear and ive disconnected the pressure switch blown down it but nothing changes, ive not done much an these newer htpts its just baffled me that the circ motor was continuously going im going back this week for another bash, any advice b4 i go would be appreciated.

thanks paul

[hilly]

Re: indesit dish Frame support

did epoxy glue work? ive just come across same problem on a ariston one

paul ❓

[hilly]

Re: hinges

thanks chris thats a better price 🙂

[hilly]

Re: zan d/w no fill

cheers chris

[hilly]

Re: Stoves oven 800df

cheers dave

[hilly]

Re: instruction manual htpt wdm73

cheers got it 😀

[hilly]

Re: WMA30

not seen it do it she says its done it about three times in the last month i think she may be imagining it but ive asked her to try it for another week and report back to me (she also told me the softner wasnt going out of the tray and she said she’d cleaned it but it was blocked on the syphon when i got there i thaught she was going to accuse me of planting the gunk there?) just thaught id ask the question for when she rings up again.

cheers

[hilly]

Re: widl146uk indesit w/d

got new module and eeprom machine worked great it cant of liked the old repaired module cheers nige owe u a couple of beers now 😆

paul

[hilly]

Re: widl146uk indesit w/d

cheers dave got module ordered today eeprom on back order

thanks paul

[hilly]

Re: widl146uk indesit w/d

just to let you all know im still on with this one ive had a couple of other engineers look at it cos i thaught im going mad they seem to think its a module fault as well one of them has had a module on order for a hotpoint which apparently there is a replacement module which fits most of the ranges now his & mine both change to this one which im hoping to try on my machine but everywhere seems to be out of stock i spoke to indesit last week they think it could be another couple of weeks till they are in stock. does anyone know if these boards have to be programed to fit different models or is it a straight swap? heeelllp pls

thanks paul; 🙁

[hilly]

Re: widl146uk indesit w/d

thanks for reply ive just got the module back from emw i sent it back for them to check but it all works ok on their test rig so im going back again tomorrow to scratch my head again (i was advised it could be an edge connector problem and was told to tighten the pins but this didnt work) its bound to be something simple im missing after all you dont get any more basic than an indesit. i will let u know if i solve it

thanks paul

[hilly]

Re: daz with conditioner for serv wash?

Thanks

Paul

[hilly]

Re: whirlpool awm1200

yes she still has it but it doesn’t say anything about it moving on.

paul

[Author]

Posts