Forum Replies Created
-
Posts
-
Re: Hotpoint CTD00P
That switch is listed for the CTD40 onwards, it is not listed for the CTD00 model range, wiring to float switch is different.
The wiring diagrams show a different set up for the CTD00 and the CTD40/80/85.
Do a part number search HERE with C00095596 then check the model numbers, the CTD00 is not listed. Do a search for the correct part number C00205873 and you will get no results. 🙁
Re: Hotpoint CTD00P
Just has a root around, I have a couple so if you really get stuck then PM me your address and I will get one to you. 🙂
Jim.
Re: Hotpoint CTD00P
C00205873, a bargain at £7.00 as well. not coming up on Partfinder as obsolete but that doesn’t mean much TBH. 🙁
Re: Hotpoint LFT 11M132 Dishwasher H fault
If it is under five years old I would advise getting Hotpoint out to it under the five year parts warranty and just pay the labour.
The display pcb may be faulty but that costs over £100, fault could also be main pcb which would cost much more.
The main motors and heaters are also prone to failure on these Indesit made machines. 🙁Edited your first post. 😉
Re: Jockey pulley burning out on Hotpoint/Indesit dryers
Again a bit OT but found another bit of info that may be useful, it appears there is a kit to repair the drum shafts on the riveted drums now.
Re: Jockey pulley burning out on Hotpoint/Indesit dryers
Digging further it is based on the Aqualtis dryer range, pulleys different to the early dodgy ones as far as I can see. 🙂
Re: Jockey pulley burning out on Hotpoint/Indesit dryers
:tup:
Would be interesting to see serial number as that model was introduced in July 2014.
Re: In search of the fourth cord
I despair, how on earth could my post be deemed as ‘not helpful’ :angry4:
Jim.
Re: bosch dishwasher
On the contrary it is very helpful, if you bother to click on the link in my second post you will see info from NomadPaul, a Bosch engineer.
Re: bosch dishwasher
Also if you do a search ( easy to do ) you will find THIS
Re: bosch dishwasher
Model number is always a big help. 😉
If you go to the top of the home page and look under Help & Advice you will find fault codes, sadly E19 is listed as ‘not used’
