Forum Replies Created
-
Posts
-
Re: Leave him to Dave.
He is very resourceful and a likeable sort of chap in his own way, and very polite which helps. 😀
Re: Indesit d/w IDF125 – All lights flashing
Did you look HERE ?
Re: condenser dryer tc71 not heating
The original post is 10 years old, and the thermostats are mentioned in the original and subsequent posts. 🙁
Re: Neff B1120W2GB/01 Help
Re: DEMO MODE
Is this a wind up? You posted an identical post on the 16th of November 2016. Have you not been able to sort it yet?
Re: BEKO control module
]Already had her next door neighbour on the phone, as she had an Indesit I advised her accordingly. 😉
Re: BEKO control module
hyg-dip wrote:Hi Jim
Andy advised no account required, but can you please provide your contact number or ring AWS on 01603 412324 in order that we can progress the module for you
Thank you
Paul
AWSPart arrived this morning, excellent service. :tup:
Re: BEKO control module
It was a bit like a disaster zone in this small close of about 20 houses. 8 or 9 British Gas vans there fixing all the broken central heating units.
The washer I went to had a totally fried main module, also taken out the plug fuse. The power surge had also damaged 3 TV’s, the Sky box, telephones, microwave and burnt out the motor to her Stannah stair lift. :zap:
Re: BEKO control module
Ta, not ben out to it yet but the small cul de sac the customer lives in has apparently been hit by a massive power surge. Taken out virtually all connected electronic devices in every house, phones, TV, audio, washers, refrigeration etc.
Jim.
Re: Guidance on premature failure of replacement bearings
In over 45 years I have never measured the torque when tightening a drum pulley on countless types of washing machines.
Some manufacturers, Zanussi for one sometimes supply a special grease for applying inside the rubber seal, not sure but I think it is sold in the store here.
The seal is usually fitted as far down as you can get it, usually tight up to the bearing. You would have to ask re the seal alone.
