Forum Replies Created
-
Posts
-
Re: Indesit IWDE12 Help
Looking at the user manual the lights should flash when delay is activated, if yours are on steady that does suggest an electronic fault.
Re: Indesit IWDE12 Help
PCB = printed circuit board, the sad truth is that the electronics in Indesit machines are known to be rather suspect and if the main board is faulty then it does mean that in all honesty it is BER. (Beyond economic repair) 🙁
Has anything been spilt over the front of the machine that could be causing the buttons to stick?
Re: Indesit IWDE12 Help
Have you checked in your user manual to find out how to cancel the delay settings?
You could also try unplugging the machine for a while to see if it resets.
That is not a recognised error code so if all else fails then either of the pcb’s could be faulty.
Re: long shot
Pity it’s posted on it’s side.
It is a Creda/Hotpoint built oven, several models, what are you looking for?
Re: Hoover DYN9144DG gone bang !
Door locks often fail on these, taking the pcb with it 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time.
You can usually release the door lock by removing the lid and prising the latch free, lock is usually near to the top so easy to access. No emergency release AFAIK. 🙁
There are a few different versions so the long number beginning with 3100**** is needed to verify exact model.
Re: Help needed!
The electronics on these ‘Indesit’ machines are known to be very unreliable.
F04,F05 and F11 all relate to various drain pump faults. Have you checked and if needed cleaned out the drain pump filter?
F01 is more of a problem, it is supposed to be a main motor triac fault but it can be anything from a loose wiring connection to a motor or main circuit board fault.
If it is under five years old then you are covered for all parts and Hotpoint (Whirlpool) will only charge you for the labour which is just above the £100 mark AFAIK.
Re: Whirlpool to do a recall on Hotpoint dryers
Or as the car industry used to say, the biggest mechanical failure on all cars is the NUT holding the steering wheel. 🙁
Re: Zanussi RW 801 Bits of putty like substance on clothes
As this machine is obviously not a dishwasher I thought it best to move it to the correct forum. 🙂
Re: Hotpoint Quadrio model CM04FFE /FF4D KUK
Would need the full commercial code to identify correct parts.
Would also suspect that if it was originally part of a safety modification then it should still be referred back to Hotpoint (Whirlpool) .
You might find that after all this time that a concessional replacement mat be offered though.
Re: hotpoint dishwasher LFT321
Wash pump or wiring between motor and pcb faulty.
NB. This error code only relates to model LFT321HXUK
Jim.
