Forum Replies Created
-
Posts
-
Re: Hotpoint WDD960 F15 error with Flashing LED’s
F15 is listed in the official manual as ‘possible’ heater dryer relay fault which isn’t the best of help.
Machine will self test so error codes for dryer can/will show during other cycles.
Re: Help wanted.
Seem to remember seeing a link to that site some years back Chris, never forgot that weird wash action. 😆
Re: hot point aqualtis 1400spin
75{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of the time F05 is due to a blocked drain pump filter, very rarely a pressure switch fsult
.Re: zanussi ZJD-1219 NOT WORKING PLS HELP
GuyW wrote:
One thought – with the machine power button off – does it trip when you switch on the supply at the wall socket? If so it suggests a damaged power cable to the machine.
Or it could be the mains filter, or the main power pcb, or the door interlock or even the main motor, all of the above can be in circuit as soon as the start button is pressed.Unless the machine has been tampered with, had a serious OOB condition or been manhandled in any way the possibility of the wiring connections to the ‘control panel and selector switch’ becoming bent is remote in the extreme. :rolls:
Re: zanussi ZJD-1219 NOT WORKING PLS HELP
You have a short circuit or insulation fault. You will need a decent multimeter or megger to isolate the component or wiring that is causing this, no one possible cause I’m afraid.
Re: Hotpoint Fault codes H20 and F01
iadom wrote:
F01 could be faulty motor, main power module in base or faulty wiring connections between motor and module.
I had answered that one earlier.;)
Even a change in the wind direction is enough to cause these modules to fail.
Re: Hotpoint Fault codes H20 and F01
iadom wrote:That is the power module, no way to test but you could send it away to EMW Electronics who do test/repair pcb’s.
Nothing is puzzling about the electronics and spurious error messages on these machines, the circuit boards are pants. 🙁
I refer the honourable gentleman to my previous answer. 😉
Re: Oven tripping electric
kaibart wrote: suggestions?
Yes, for the second time of asking, please apply for TRADE ACCESS :rolls:
Re: Hotpoint Fault codes H20 and F01
That is the power module, no way to test but you could send it away to EMW Electronics who do test/repair pcb’s.
Nothing is puzzling about the electronics and spurious error messages on these machines, the circuit boards are pants. 🙁
Re: Hotpoint Fault codes H20 and F01
H20 is ‘supposed’ to be a water supply problem.
F01 is not a control module fault, again it is ‘supposed’ to be a motor triac fault.
The Indesit electronics in these are known to be very suspect so error codes are only a rough guide.
F01 could be faulty motor, main power module in base or faulty wiring connections between motor and module.
Re: Hotpoint WDL 540
Need full model number and commercial code to be certain. The valve with the extension has never been available as a spare. In some cases a new, longer dispenser top with valves is required.
Re: Belling fan oven motor?
Err…….., yes Don that is the one I linked to but couldn’t see my exact model number. 🙂
Re: Belling fan oven motor?
Can anyone confirm it is THIS one?
