Forum Replies Created
-
Posts
-
Re: Indesit DIF 16 UK problem
The rating plate is usually stuck down the side of the stainless steel inner door.
The numbers are for the machine, not the part.
Re: Zan error E41 or E51?
It is a bit confusing, the door lock I tried wasn’t the exact one for this model but same contacts, none of the stages of the diagnostics would actually run and as locking the door is the first step it is making me lean towards that.
Motor is a clean as a whistle, very lightly used machine TBH.
I am going to get the correct door lock and keep my fingers crossed. 🙂
Re: Indesit DIF 16 UK problem
Not necessarily,
There a several versions of the DIF16 UK models and the same control board does not fit them all.
The FULL model number and the serial number and commercial code from the rating plate are needed for correct parts ID.
Re: Indesit DIF 16 UK problem
If you are lucky it just be the buttons sticking on the control pcb, they are ‘touch’ buttons but people do insist on pushing hard on the buttons. Even that tiny pcb is over £50 though.
Re: Word Count
Looks good to me, an addition along the lines of Chris Chantrells’ sig would also be a good idea.
Please don’t email or PM trade members asking questions, this is a perfectly good forum, use it!
Had one or two recently that have registered and not bothered to post but just fired off a PM most of which I now ignore, especially as I always seem to read them when I am away from my main PC. 🙁
Re: Also washing machine 10504
Do they look anything like THESE
Re: Indesit DIF 16 UK problem
Hard to say, it does have some of the worst electronics on the market TBH.
Are you getting any lights flashing on the front?
Re: Hotpoint dryer fault help needed
Has your machine got a green spot sticker on it anywhere?
If not you should go HERE
Re: Whirlpool to do a recall on Hotpoint dryers
Well that inch thick layer of fluff inside the rear seal should be scraped away by the pop rivet for a start.
But I forgot, ‘it’s the suppressor’ ❓
Re: AQXXF149PMUK
Don’t see many of these round here, I though I had your email address but can’t find it. PM me and I will send you the manual.
Jim.
