Forum Replies Created
-
AuthorPosts
-
iadom
ModeratorRe: In search of the fourth cord
Well I was hoping it would drift of into the ether but as usual some people can’t resist making stupid comments. might be time to pull it if it gets anymore. 🙁
iadom
ModeratorRe: Whirlpool to do a recall on Hotpoint dryers
Have to disagree, the condenser aperture is too high off the ground and far too narrow for any Hotpoint based dryers that I have seen.
iadom
ModeratorRe: Hotpoint washer WMFG611 futura
The main (weak plastic ) control knobs are often prone to breaking on these Indesit machines.
Two different knobs depending on colour.
iadom
ModeratorRe: ZDC68560 Prod 91609680204
PM me an email address Alan.
Jim.
iadom
ModeratorRe: Freezer/Fridge
You need a holiday Don. 🙂
iadom
ModeratorRe: Freezer/Fridge
But surely that is a fridge/freezer Don, big fridge/small freezer when the OP wants a freezer/fridge, big freezer/small fridge?
March 29, 2016 at 2:15 pm in reply to: is it normal for Flow meters to be connected to Neutral? #436640iadom
ModeratorRe: is it normal for Flow meters to be connected to Neutral?
Make and model number. ❓
iadom
ModeratorRe: Whirlpool to do a recall on Hotpoint dryers
Doesn’t look like a Hotpoint based dryer?
iadom
ModeratorRe: Hoover Optima 716df Smoking
More likely to be a new machine, does the drum appear to run a little off centre? Very strong possibility the drum support has fractured. 🙁
iadom
ModeratorRe: Ignis ( Whirlpool ) D/W
No, it’s a later one with heater in the pump housing.
iadom
ModeratorRe: In search of the fourth cord
Of course, if you had to take bets on just which idiot would reply to the post the number one candidate has duly stepped forward. :rolls:
iadom
ModeratorRe: In search of the fourth cord
No doubt it will soon slip into oblivion.:)
iadom
ModeratorRe: Creda Europa Solar Plus fan oven cut out
Looking at the nearest model wiring diagram that I have to that model and all others in the same range it does point towards a faulty door micro switch.
-
AuthorPosts
