Forum Replies Created
-
Posts
-
Re: Hotpoint WMM39A very short spin
Could be a loose tacho magnet, have seen them come loose on FHP and CESET motors but you should get a different last error code for that. Does sound as though the pcb is at fault but the chances are that something else has blown the triac. 🙁 give all the wires in the motor plug a good tug first, they are prone to breaking without being obvious.
Module is a C00202236 ( 1604321)
Sent from my iPad using Tapatalk HDRe: Hotpoint WMM39A very short spin
Have you tried the last error detected routine for the WMA machines shown in the Known Error Codes thread, it is the same basic machine?
Re: Spam
It was in one of the boxes that come up across the forum pages at the top and bottom, it was in the public forums, assume those are Google?
Re: Spam
Not really spam at all but I have just seen a banner add for NAC flashed on screen. :rolls:
Re: Drum spider ? Should I bother repairing or just replace
Never, ever had one squeak after fitting new bearings, only heard the low speed, seal squeak on machines a few years old with original bearings, even then it rarely caused a problem long term.
Sent from my iPad using Tapatalk HDRe: Drum spider ? Should I bother repairing or just replace
None at all, there used to be a spacer between the bearing and the seal but that was removed and the thicker seal was used which as you have noticed covers the drain hole anyway.
Re: Indesit WIB111
F01. Motor triac short circuit. Check motor & module connections, faulty pcb a likely cause. 🙁
Re: Creda 37761
Could we make this a little clearer, you are asking if anyone has one of these, not if anyone knows the part number. ❓
Re: Hotpoint WMD962P(UK) Problem
Click4 wrote:
Still cheaper than a new machine.
Still a poor quality Indesit machine. 🙁Re: Smoke damage to kitchen
There seems to have been a rash of people answering posts that are from years ago recently, does nobody look at the date before answering. 😥
