Forum Replies Created
-
AuthorPosts
-
iadom
ModeratorI think that little nozzle is to force the arm to rotate, most dishwasher lower arms have a couple of the jets spraying to the side to achieve this.
iadom
ModeratorYour machine has a 3 phase brushless motor. I installed and maintained a large number of the ISE 10 machines and never, ever had a single problem with a mains filter. 😉
In fact I’m willing to bet that our UKWG’s store has hardly ever had to supply a mains filter for an ISE10.
iadom
ModeratorCould be the commutator on the armature is damaged, something that can happen when using poor quality carbons. Usually that leads to serious arcing and blown pcb’s on BSH machines though. Getting anything ‘used’ from eBay is always a risky business.
iadom
ModeratorDon’t think those small Chinese modules are anywhere near that price. Would advise checking the wiring plug very carefully and check for leakage from where the soap inlet hose is slotted into the drum. You will need to peel back the door seal to check.
iadom
ModeratorThe first number of serial number is supposed to be the year so 3 could be 2003 or 2013, second two numbers are month.
iadom
ModeratorMy mistake, it should be part of serial number. My lists may well be out of date because they give it as Sept 2013 which I don’t think is correct?
iadom
ModeratorMe neither.:(
iadom
ModeratorThink you may need the commercial code not serial number.
iadom
ModeratorLooks like it would work for me but I am sure there was a simple merge option in the drop down list well after the forum upgrade???
iadom
ModeratorThe official service manuals only contain the same circuit diagrams as found on the sheet in the machine. Like 95{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} of domestic appliance manuals they do not include circuit board component information.
iadom
ModeratorCable tie was one of the methods I used.;)
iadom
ModeratorExamine the small connector plug to the pump, I have seen the slightest sign of arcing due to water ingress damage this plug but you really need to look very closely to see it. Sadly if that is the case then module damage has often occurred. A quick visual on the component side of the module usually shows signs of component damage. The water inlet hose from the soap dispenser often leaks as the adhesive sealant deteriorates.
iadom
ModeratorThe workshop manuals do not go down to board level schematics or component values.
iadom
ModeratorAn insulation fault on the heating element is a known cause of spurious F03 errors on these.
iadom
ModeratorIt’s all a fiendish plot from the Chinese investors who bought a stake in Manchester City. Playing behind closed doors will give City a huge advantage as the are well used to playing in empty stadiums.:D
-
AuthorPosts
