Forum Replies Created
-
Posts
-
Re: hotpoint BWM 129 washer
Thought I remembered putting it in. 😉
Re: Dishwasher Hotpoint BF71 ‘F’ code and continuously drain
A Bosch based machine, error codes are usually given by showing E and a number but your symptoms suggest a flooded base.
You will need to drag the machine out, unplug and then tilt it to one side or backwards. I water runs out then this confirms the base is flooded. You will then need to find the source of the leak.Re: Hotpoint Dishwasher LST216A
Missed your post yesterday, was away from home all day. Thanks for letting us know the outcome.
Re: Zanussi Lindo300 Error code E66
Available HERE
Re: Zanussi Lindo300 Error code E66
That could well be good news, E69 means heater O/C.
Does suggest that it would be well worth trying a new heater. 🙂
Part number is. 3792301008
Re: Zanussi Lindo300 Error code E66
Possibly translated from Chinese so here it is. 🙁
14.1 LAST ALARM READING AND RESET
The alarm indication is also used when the user interface (UI) enters LAST ALARM mode, that is when the user pushes the “special key” combination while the board is in normal mode or when the main knob is set to the 11th position while the board is in diagnostic mode.
Information “last alarm reading and reset” ? While this mode is set, it’s possible to read the code of the three latest alarms, starting from the most recent. ? Each time the leftmost key (Perfekt 10, Pilot 2 or POne levels) or upper button (Blue Fire levels) in the “special key” combination is pressed, the UI starts displaying the following alarm code among those stored in memory. So, if this button is pressed once while the last alarm was being displayed, the last but one alarm is displayed instead; after the key is pressed again, the last but two alarm code is shown. ? Pressing at any time the rightmost key START/PAUSE button in the “special key” combination the displayed sequence comes back at once to the latest alarm. ? It’s possible to reset Last alarm pressing the defined key combination (START/PAUSE and the closest one for every UI) when in Diagnostic mode with selector in 11th position.Re: Ise aw23 re- spares
Usually possible to adapt a bog standard double valve, leaking from dispenser top???
Sometimes leak from were the overflow hose is pushed into the back of dispenser, never had to change a dispenser top before.?
If you look at the Amica parts list you may find something or get in touch with Bryan ( r600a) he will have both of those parts amongst the stuff I dropped off a few weeks ago.
Re: Zanussi Lindo300 Error code E66
Not at home now so don’t have access to tech info. If no one replies I will look it up tomorrow.
Re: Zanussi Lindo300 Error code E66
Did you actually try running the machine with the wires disconnected?
The last error will remain in memory unless cleared.Re: Hotpoint Dishwasher LST216A
Pressure switch failure not common and wouldn’t lead to any noises, pump failure very common and always causes noises that shouldn’t be there.
