[jd]

Re: Flashing whirlpool F/F

Hi a1al
I have had a few like this assume its the side by side type it is front control board fault but be careful after replacing some go into another error display ie 00 flashes on freezer and fridge side flashes F0 you may also need to replace power board at back as a pair not sure why could be old and new not compatible could get rather expensive

jd

[jd]

Re: De Deitrich oven DOD448BG11

Hi Guys
Thanks again for your help turned out to be door lock after all but much easier to find with diagram

Cheers jd

[jd]

Re: indesit di620uk

Hi
The Board should be c00143206 this happened to me some time back and it just hasn’t configured correctly

JD

[jd]

Re: De Deitrich oven DOD448BG11

Hi guys have checked cut out yes ok it does have door lock so worth a try
have sent email Bob

thanks again
jd

[jd]

Re: Schreiber APM6855

I have had this problem on a couple of occassions and changing the no frost sensor in the evaporator seems to cure the problem, it is a relatively cheap part around £15.00 available from connections sorry not sure of part number, hope this helps jd.

[jd]

Re: apm6855

I got same problem with this model all checked out ok gone for control pcb situated behind display at top, cost £57.00 direct from diplomat so hope it cures it should arrive this week. Will let you know if it works

jd

[jd]

Re: Indesit DI620uk PCB

Hi you have a bit 100 card not sure of this model but check to see if a coding plug is fitted to board usually at top left corner, if so you need to transfer to new pcb
hope this helps.

jd

[jd]

Re: Beko wma665w

Don’t see many beko but is there any chance pump goes o/c after wash bit like some of the older servis machines think they got a neutral feed from pump circuit, just a thought, best of luck with it. 😀

[jd]

Re: Whirlpool side by side RS20BRSB20AG

Thanks Brian worth a try as the board i fitted was a superceded part and i noticed the water filter light was not on it.

will give it a go

John.

[jd]

Re: smeg dishwasher

while browsing i found the error codes you mention will try the dispenser solenoid as you suggest.

many thanks john.

[jd]

Re: Hotpoint wmt 02

Hi there i have had this problem does machine fill and cut out when motor starts if so possible broken tacho wires in harness close to a cable tie you may need to trace back from motor and give them a tug as will not be obvious. hope this helps.

[Author]

Posts