Forum Replies Created
-
Posts
-
Re: You must be CORGI registered to work on gas!!!
yes u can fit a door seal etc etc but what say if the flame picture from the burner is incorrect, are you able to identify it, are u able to correctly repair it are you able to serve a notice on the appliance if its unsafe etc etc, basically you have to treat the applaince as a whole and if ure not corgi registered and something goes wrong or is incorrect you were the last person to touch it! is it worth the risk?
Re: “You must be CORGI registered to work on gas”
i beleive there is a freephone number that corgi have setup to shop people who are carrying out work not registered. Bottom line is for all of us who pay and go up the right route why should other people get away with it.
Taken from the hse website……
In particular the Regulations require gas installation businesses
to be registered with CORGI, which is approved by HSE to maintain a register of gas installation businesses.
All gas fitting operatives are also required to be able to demonstrate they are competent to undertake gas work safely normally by being assessed against nationally accepted standards.Wether the person(s) is competent is neother here or there they should be regsitered like most of us are.
Re: Corgi regulations for the installation of gas hobs
each manufacturers hob is different, that info is with the installation instructions that come with the hob.
i read in the corgi magazine a few months back i think it was that they are recommending without this info to not install.
The hob manufacturer should be able to give you this info.
Re: Cutting a chimney hood
i would take it to a fabricator who has a plasma cutter thats the best way of getting a non scorched and clean cut i think.
Re: The cheek of the bloke!
its a cheek to say the least. even though the like of indesit do it from the factory. but having said that how many ppl actually bother to look i wonder?
Re: Zanussi FLE1416W Leak
in the past i have had quite a few leaking on final spin, the tub half seal was always the culprit but they changed the design of the seal, havent seen one leaking in along time now.
Re: cannon winchester
yep she has her instruction book but there is not a model number reference in it just ‘winchester’
Re: House of Horrors
http://www.itv.com/uploads/filelibrary/ … 741344.pdf
page 9 of the pdf for the low down on it.
Re: Mobile phone and Sat Nav in one!
no you dont have to buy additonal software but you may have to download the maps (which will cost i think) i got mine from o2 which came with a 1gb mem card and the maps preloaded.
