Forum Replies Created
-
Posts
-
check the wires at the motor plug to see if one is loose or broken, because if you do not refit the plug wires to the side of the motor after changing brushes with a cable tie then the drum movement pulls them.
hi Dave that would be great, if you send it to don@awmrepairs.co.uk that would really help
no other lights are flashing, the wash light stays on as normal and the end light comes on as the machine drains and both stay static, no leaks and heater is ok
Re: Bosch washing machine not doing program
Might be worth checking the motor plug wires for a loose or broken connection.
test continuity between motor plug end and PCB end.Re: heater element 1888130100 poss req
check the wires that go through the bottom of the door as i have had a few Beko machines that will not heat ( element ok etc ) and its been a broken wire.
Jim
Re: LG Leak from Soap drawer
not sure if that model has a vent hose but if it does make sure its not blocked.
Re: Hotpoint IWDE126(UK) Door lock issues.
had the same problem a little while ago and it drove me up the wall too.
machine would run perfectly through the cycle and then the door would not release.
found that as the machine reached top speed 1400 the door lock would click and cause the problem, run the machine at 1200 and no problem at all.
brushes were fine and its still working ok but with a lower spin speed.Re: Bosch WAQ243D0GB/09 door lock problem.
just a thought, is the plastic pull strip in the right position and not snagging on anything?
Re: Bosch WAB28060GB/05 no drum action
have you checked the continuity across the motor plug pins to see if the internal fuse has blown?
Re: Beko DPU 8360w not heating
thanks for that Seamy
NTCs are ok and the compressor is running so assuming must be a leak going on.
think i will bail on this one!
you think with modern tec it would show a fault code though or go to error instead of just keep running.Re: whirlpool w/m AWO/D5716 error F08
result!!!
dry joint, thank you for pointing me in the right direction
